python 4211p with immobilizer bypass wire

Hello guys. I would like some confirmation on my wires before i jump into this. If anyone sees anything wrong please let me know. Also if there is a question mark next to it im not sure about it. Thank you Remote start - python 4211p with Dball2pro with XCRS (extreme capacity relay satellite) Car - 2006 honda civic si 16 pin connector pin 3 Immobilizer Data: ORANGE / Black to pin 3 on immobilizer plug pin 6 single wire can Lt. green to pin 4 on immobilizer plug pin 10 (-) lock output GREEN/ black to Pin 28 driver side kick panel (34 pin plug) pin 13 (-) unlock output Lt. Blue/ black to Pin 27 driver side kick panel (34 pin plug) XCRS plug Violet + Starter output (starter side) to Cut yellow in half at ignition switch starter side Green starter input (from key) to Cut yellow in half at ignition switch Key side Red + 12 v input to BLue + Ignition switch Orange Accessory output + to Orange + Igniton Switch Red +12v input to BLue + Ignition switch Pink + Ignition Output (also input to yellow wire in ribbon) to ??? RED / wht + Fused 30a ignition 2/ Flex relay input to NOT USED Pink/ wht +ignition 2 / Flex relay output to NOT USED 18 pin connector Pin 3 gray Hood input - to Hood pin on bay Pin 8 BROWN / blk Horn - to Orange Fuse box rear 16 pin plug pin 13 lt blue trunk input - to ??? Trunk release is green but + kick panel 42 pin plug Pin 17 brown siren output + to NOT USED 12 pin connector pin 1 &7 white Parking light output + to ??? Pin 2 &8 white / brown Parking light input + to ??? pin 9 black Ground - to Body pin 10 red 12V + to BLue + Ignition switch If i am missing anything please let me know. Thanks

no one? Where do the Flex wires go? What about the light output/input? Anything on Pink + Ignition Output (also input to yellow wire in ribbon) to ?. Any help please

Red, Red and RED / White will all go to 12v (white) at the ignition switch. Pink goes to ignition (blue) at the ignition switch. Pink/White goes to 2nd ACC (red) at ignition switch. (Program to ACC in menu instead of IGN) Trunk input is for an alarm or manual trans. White will go to your + parking light wire (red @ fuse box, lt green plug pin 19) WHITE/ brown goes to 12v (white) at ignition switch or tie it in to your other 12v wires.

Thanks so much for your input. Question. I want to trick it to think my car is auto. Will this wiring be the same? Will I need the trunk when doing this? Someone mentioned a neutral safety switch. Do I need that? Thanks for your time.

Also the very last red 12v on the pin 10, wood that also go to the white?

I want to trick it to think my car is auto. Bad Move. If car is manual transmission.When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Why is it a bad move? As long as im careful with not leaving it in gear, what can go wrong? I'm in and out of my car a lot and do not want to deal with the procedure of a manual.