alarm install help

Home / the12volt's Install Bay / Car Security and Convenience / alarm install help (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

laurieandmike

Member - Posts: 4

Joined: June 08, 2003

Posted: June 08, 2003 at 6:35 PM / IP Logged

hi there i am new to this and need help as there is no installers arround here

i have a new alrm with a regular and a backup siren with a key and need help installing it

i found help here on the shocksensor so that should be ok now but i need to know how to hook up the second backup siren on the siren it says

RED 12V+

BLACK GROUND

WHITE +TRIGGER

BLUE -TRIGGER

I CAN FIGURE OUT THE RED AND BLACK BUT WHAT TRIGGER WOULD I HOOK IT UP TOO AND WOULD I MOUNT IT IN THE ENGINE COMPARTMENT?

ALSO ON THE WIRING IT SAYS WHITE/ PURPLE IS FOR SECOND UNLOCK WHATS THAT FOR

AND IT SAYS ORANGE IS LAMP BUT WHAT LAMP PARK LIGHTS/HEADLIGHTS/DOMELIGHT WHAT ???

HORN-300MA DO THAT GO TO THE HORN GROUND?

PLEASE HELP ME ASAP

THIS IS GOING ON A 99 DODGE DAKOTA SPORT

THANKS MIKE

lauriecorbett@ns.sympatico.ca

laurieandmike

Member - Posts: 4

Joined: June 08, 2003

Posted: June 08, 2003 at 6:37 PM / IP Logged

also where do the push lock go ?

drivers door/hood/what?

mike

cool_greg

Copper - Posts: 125

Joined: February 20, 2003

Location: New Zealand

Posted: June 08, 2003 at 8:00 PM / IP Logged

WHITE +TRIGGER

BLUE -TRIGGER

Check your alarm unit to see if it is + or - output for the siren, most likly +, but check

HORN-300MA DO THAT GO TO THE HORN GROUND?

- no, see diagram below

hope this helps out!!

Constant 12V+Pink/Black Ignition Switch Harness Starter Blue / YELLOW Ignition Switch Harness

Ignition Blue (+) Ignition Switch Harness

Ignition 2 BLACK/ White Ignition Switch Harness Accessory BLACK/ Orange (+) Ignition Switch Harness (Heat/AC)

Tach BLACK/ Gray Coil

Neutral Safety Wire Yellow/Blue / YELLOW 32 Pin Connector Pin 6 right of Engine (PCM)

Brake Switch WHITE/ Tan Brake Switch

Trunk Pin n/a Common with Doors

Parking Lights BLACK / YELLOW (+) Light Switch

Head Lamp Light Green (-) 14 Pin Connector Pin 6 at Switch

Factory Disarm BLACK/ Orange (-) 18 Pin Connector Pin 10 Module Passenger's Kick Panel

Door Trigger Yellow (-) Courtesy Light under Dash Door Lock Orange /W (REV) Driver's Kick Panel Reverse Polarity

Door Unlock Light Green Driver's Kick Panel Reverse Polarity

Driver's Lock ORANGE / Black Left Side under Dash Driver's Unlock Pink/Black Left Side under Dash Passenger Unlock Pink/Purple Left Side under Dash Horn Wire BLACK/ Red (-) 74 Pin Connector Pin 17 left Kick Panel

Windows Up LF=Light Blue, RF=BROWN / White

Windows Down LF=White, RF=PURPLE / White

I'm not too sure what you mean by push lock, but you need to install a pin switch for the hood if you want the alarm to be triggered if the hood is opened, if not don't bother hooking up the wire for it.

Just a Guy, Wiring up those Vehicals

---------------------------------

Gool_Greg

laurieandmike

Member - Posts: 4

Joined: June 08, 2003

Posted: June 08, 2003 at 8:42 PM / IP Logged

all it says for the siren is a white /red wire and then ground

the diagram dont have anything there input or output and i already have one siren on the system but need to know how to wire the backup one with 4 wires

i also need to know where the lamp wire hooks too its orange

and what the second unlock wire is for(WHITE/ purple wire)

and horn wire(green) and says - 300ma

i see the diagram and dont see anything there that helps

sorry if i seem stupid but alarms are all new to me

i install sterios etc but not this stuff

so the pin switch can be put in the door trunk hood where ever i want it to go?

the alarm model # is a am373

thanks for help so far and i also got one for a 98 honda civic with door locks etc

thanks

mike

cool_greg

Copper - Posts: 125

Joined: February 20, 2003

Location: New Zealand

Posted: June 09, 2003 at 6:19 AM / IP Logged

the orange goes to the park lamp switch BLACK / YELLOW

The existing sire wire goes to the white + wire on the new siren

forget about the 2nd unlock purple wire, you don't need it

the horn wire (green) goes to BLACK/ red wire at 74 pin connector on BCM

the pin swich where ever it will actually work and be pushed down with the hood closed.

As for the 98 civic, there is quite an extensive database here of wiring diagrams that you can use

Just a Guy, Wiring up those Vehicals

---------------------------------

Gool_Greg

laurieandmike

Member - Posts: 4

Joined: June 08, 2003

Posted: June 09, 2003 at 2:54 PM / IP Logged

do the park light one have to be on a relay?

cool_greg

Copper - Posts: 125

Joined: February 20, 2003

Location: New Zealand

Posted: June 09, 2003 at 4:46 PM / IP Logged

most likley not, most alarms can handle switching the parking lights

Just a Guy, Wiring up those Vehicals

---------------------------------

Gool_Greg

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

alarm install help

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.