toyota 02 highlander

vehicle wiring information help!sosa

     12V      white & blu/yel     +  ignition harness                                    STARTER      BLACK/ white          +  ignition harness                                   IGNITION      black                     +  ignition harness                 SECOND IGNITION       BLACK / YELLOW        +  ignition harness                            ACCESSORY       pink                       +  ignition harness                   PARKING LIGHTS        green                   +   driver kick panel                 PARKING LIGHTS        GREEN/ red             -   headlight switch                         HEADLIGHTS        RED / blue                -  headlight switch                    DOOR TRIGGER        GREEN/ YELLOW       -  ign. key cyl. illumination  *1DOME SUPERVISION         comes on with unlock   TRUNK/HATCH PIN          WHITE/ red            -  driver kick panel                               HOOD PIN        GREEN/ black         -  top plug, pass side junc box    FCTRY ALARM ARM        arms with lock         FCTRY ALRM DISARM       disarms with unlock DISARM NO UNLOCK        red to blue         -  steering column     *2             TACHOMETER       WHITE/ green         28 pin plug, pin 27 @ ECM *3                BRAKE WIRE       GREEN / WHITE         +  brake pedal switch     

 The doorlocks are a stinkin' big job requiring that you normally go inside the drivers door.  The following colors might work for your Highlander but are principally for a Tacoma.

POWER LOCK           BLACK/ blue             -  pin 11 in 22pin plug front of fusebox

POWER UNLOCK     purple                   -   pin 16 in 22pin plug front of fusebox

NOTE: Some models have an immobilizer system that needs to be bypassed during remote start.   

*1 To avoid the dome light delay, go to the Body ECU behind the glove box to get the individual door trigger wires. In the 19 pin plug, the driver door is RED / blue in pin 11 and the rear hatch is WHITE/ red in pin 6. In the 17 pin plug, the front passenger door is RED / blue in pin 16 and the 2 rear door is red in pin 15. Use all wires and diode isolate each. 

*2 This is the key sense wire for the ignition switch. The wire changes colors after a junction plug. It is red on the ignition switch side and blue on the other side. Using the status output wire from the remote start to ground this wire will disarm the alarm without unlocking the doors. 

*3 The ECM (Engine Control Module) is behind the glove box, it is the module to the left.   

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

You shouldn't have to go into door panels on the Highlander or Tacomas. The blk/blu and purple are in a molex plug in drivers kick panel. What kind of alarm are you installing?I'm Don.I can answer all your security questions. I have 12 years in the industry.