Installing keyless entry on 2000 Cavalier

Home / the12volt's Install Bay / Car Security and Convenience / Installing keyless entry on 2000 Cavalier (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Bulletballet

Member - Posts: 2

Joined: July 04, 2004

Location: United States

Posted: July 04, 2004 at 2:18 PM / IP Logged

Hello.

I'm somewhat of a newcomer to vehicle electronic installation. I've installed car stereos, amplifiers, and streetglow systems. A friend of mine purchased a keyless entry system for his 2000 Cavalier, and the diagrams it came with are subpar at best. The vehicle does not come equipped with a stock keyless entry, so I'd like help on the following things:

1: Does anyone have more detailed schematics of the vehicles wiring assembly?

2: Since the wires are only about 3 feet long, and the main problem is getting it to run to everything (including the horn, which is located right near the passenger side front bumper) does anyone have suggestions for mounting places?

3: What exactly do I need to find (ignition wires, lighting wires, etc) and the locations of each.

If anyone can help, I would be in so much debt to you, it's unfathomable. Thank you.

You will not find a corpse, because I have never possessed a body.

Bulletballet

Member - Posts: 2

Joined: July 04, 2004

Location: United States

Posted: July 04, 2004 at 2:20 PM / IP Logged

Also, it does not have a power door lock system.

You will not find a corpse, because I have never possessed a body.

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: July 04, 2004 at 2:34 PM / IP Logged

| 12V|red |+ |ignition harness |

| DOOR TRIGGER|grn/blk & lt. blue |- |*3 |

|TRNK/HTCH RELEASE|BLACK/ white |+ |BCM *4 |

Notes:

NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 The engine harness is found next to the battery, below the radiator hose, just above the transaxle. *2 Non keyless cars, locks are 5wi (type C) and they are mastered from the passenger side switch. Keyless cars, locks are positive trigger (type A). Also found at BCM. *3 The GREEN/ black is located in the lower drivers kick panel. It catches the drivers door only. The light blue is located in the lower passenger kick panel, and catches the passenger door(s). Tap both wires and diode isolate each. Also found at BCM. *4 The BCM is located to the left of the steering column above the kick panel.

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: July 04, 2004 at 2:37 PM / IP Logged

You going to need a volt meter to check the wires.

You can buy power lock form most car audio/alarm shops.

Depending on the keyless entry you may need relays for door locks, dome light, trunk.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Installing keyless entry on 2000 Cavalier

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.