555H bypass module

WGASCA,

I take it you found you have an immobalizer on the car.

You've got the correct module. The wires will be running from the key cylinder down the steering column and into a special module that will be right around the bottom of the steering column. They will most likely be in a seperate wiring harness. They'll be small gauge wire probably 24 AWG or even less. All the wires you need will be right there. What the 555H does is simulate a valid key when the RS sequence is started. W/O it the ECM will shut off the fuel and ignition systems so the car cannot be started. Check this out form some good info on your car as far as factory disarm and re-arm wires and their locations. Check out the link below and also do a search on "Honda transponder bypass" I found several threads that may help you but they're long and have lots of info in various pieces you'll need to read to get feel for what you need.

You'll be able to test for the KEY SENSE WIRE, It'll show -12 or +12 when you put the key in the ignition and DON'T turn it on. Obviously the + 12 and ground you can check, the wires you can't probe for are the 2 data wire(send and recv) and the sync.

Good Luck

http://www.designtech-intl.com/Content/techsupport/wirecolors/VehicleDetail?modelID=623