Compustar 2w8000 install

I am a little confused by two wires on CN1.  The green wire is marked "Ignition" on the wiring diagram.  It shares a pin with a red wire that goes to the starter kill relay.  Therefore I am assuming it is a +12V wire.  Where do I need to connect this green wire?  My first thought was the starter wire to initiate the remote start, until I noticed CN2 has a 250 mA wire marked "starter output".

There is a white wire coming off CN1 marked "Accessory".  There is no mention if this is a postive or negative wire.  It doesn't even say if it is an input or output.  CN2 also has an "Accessory Output" wire that is a 250 mA.  Where should the Accessory wire from CN1 be connected?

Thanks in advance.