455t with viper 791xv

Im having a door priority unlocking issue. the problem is this Lock works as expected, but pressing the Door Unlock button once the remote starter's remote causes the driver's door to unlock, then locks, then locks again and illuminates the factory alarm to on. I hit the remotes unlock again and unlocks all doors as it should . any ideas what the culprit could be, i have listed below my wire connections. Thanks Viper 791xv                     455t “databus interface” "H1/5 GREEN(-)doortrigger87a, vehicle door trigger 30, constant 12v fused 86, 85 455t"           =BLACK/ WHITE(-)2SECONDPULSED OUTPUT GREEN(-)LOCK(+)UNLOCK OUTPUT = GREEN (-) ARM/LOCK INPUT BLUE (-)UNLOCK OUTPUT=BLUE/WHITE(-)DISARM/DRIVER/UNLOCK H2/1LIGHTBLUE(-)200mA 2nd unlock output BLUE(-)= DISARM/ALL DOOR UNLOCK INPUT H2/6 LIGHT GREEN/ BLACK (-) factory disarm     = BLUE/BLACK(-)INPUT FROM R START 12volt constant jeep =     RED (+) 12V CONSTANT POWER INPUT grounded jeep     BLACK= (-) CHASSIS GROUND INPUT 98 grand cherokee CCD=     WHITE/ BLACK (-) CCD BUS 98 grand cherokee CCD=     VIOLET/BROWN (+) CCD BUS

I have figured it out, for some reason when the disarm wire is connected to the 455t it causes the jeep to lock and arm itself which causes the doors to lock . By disconnecting this wire from the 455t the doors operate like they should. The only issue is when remote started the facroty alarm would go off . which was fixed by manually connecting the disarm wire from viper to the disarm wire at the body control unit "black plug" purple / yellow wire . Everything finally works . I hope this helps someone as this stumped me for awhile. thanks