keyless entry confusion

I installed a Commando Universal 4 door power lock kit and am attempting to add the Keyless Entry kit that was included. The instructions for the KE-30 kit seem to be for OEM power locks and don't address separate door lock/unlock systems. The Universal lock actuators seem to be positive.(blue/green wires measurement, about 9 volts applied at actuation) The keyless entry system blue and green wires, about 10.86 volts which then drops to 0 at press of transmitter. What the hell do I do? There are no instructions for this kind of configuration, and I'm not an installer. If you have any helpful advice, it would be appreciated, but please put it in layman's terms as I'm not the brightest bulb in the lot.

I forgot to mention that I did peruse this subject on the forum before I posted but the answers either not appicable or confusing as I need specific instructions(dumb as a rock)

If you added aftermarket door locks you will need to add 2 relays put green to # 85,,,,86 and 87 go to 12v fused,,, put 87A to ground and then 30 goes to your lock wire. all 4 motors wires should be connected together then tap the lock side with #30 out of relay Hope this helps!

Do the same config for unlock,,,,,,,,,