Wiring in immobiliser

Home / the12volt's Install Bay / Car Security and Convenience / Wiring in immobiliser (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

davemonkey

Member - Posts: 12

Joined: January 27, 2006

Location: United Kingdom

Posted: September 26, 2006 at 2:06 AM / IP Logged

Alarm is a Toad A101CL with single point immobiliser that i'm fitting to my 1989 Austin Mini. I was going to make an immobiliser loop with the wire that goes from the starter relay to the starter solenoid. (The thickish brown one with the red stipe i think.)

Would this be ok? If not anyone got any ideas of what else i could use.

The reason i raised the query about using the wire from the starter relay to the starter solenoid is that it is quite a thick wire and the immobiliser wires are quite thin. Wondered if i ran the risk of burning them out? Any ideas?

Powermyster

Silver - Posts: 962

Joined: April 06, 2005

Location: Ireland

Posted: September 26, 2006 at 2:30 AM / IP Logged

better to immobilise fuel pump.. if the wires are too thin use a relay with it

Why oh Why didn't i take the blue pill

Darren Power

davemonkey

Member - Posts: 12

Joined: January 27, 2006

Location: United Kingdom

Posted: September 27, 2006 at 2:20 AM / IP Logged

I can't use the fuel pump sadly because it's mechanical! (Runs off the camshaft). Any other ideas? I'm not too bad with wiring but any advice appreciated.

Velocity Motors

Moderator - Posts: 12,488

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Fabrication. Click here for more info.

This member has been recognized as an authority in Mobile Audio and Video. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: March 08, 2002

Location: Manitoba, Canada

Posted: September 27, 2006 at 8:29 AM / IP Logged

Aside from the starter you can immobilize the ignition wire.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA

Search for other posts by Velocity Motors

davemonkey

Member - Posts: 12

Joined: January 27, 2006

Location: United Kingdom

Posted: September 28, 2006 at 2:09 AM / IP Logged

Is it ok to immobilise a wire if it's quite thick though, wondered about how much juice goes through it? Like i said in the earlier post, wondered if there was a risk of burning the immobilser wires out because they're quite thin.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring in immobiliser

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.