Does anyone subcribe to Auto Sound &Secur

I dont subscribe but i bet it was something like what i made below:

Hope this helps!

$&^+!! i have had that thing posted for a day and the time you look at it my freaking server is down!!! ahh!!

no..seriously, no wonder my site is down..the server Eriecoast.com is down..and I work for the company!!! so that means were having problems..damn!!

[edited]

Hey day,

I was in your boat about 4 months ago..i didnt know what an freaking relay did..but now its sooo simple, i dont know how the hell i could have been confused..but seriously, this might help: [take a deep breath, take your time, and read the following carefully]

A relay is nothing but a simple coil, with two wire ends, (represented as 86 and 85) Now, when this coil receives a charge from a + and - , then the coil acts like a magnet..and makes a magnetic field around it.  The relay is designed however to have moveable parts that interact with this magnetic field.  These movable parts are in relaity a switch.  The switch has a common connection (represted as pin 30)..now the two pins left over (87 and 87a) are the other two contacts for the switch. 

All it  is, is a switch that will turn on or off depending whether or not the relay (coil) gets power.

Now, back to the matter at hand; in the diagram above, pin 86 is wired to an accessory power wire that is usually hooked up to your stereo. (i used this wire because it only gets a + signal when the car is on or the key is turned to accessories)  the negative (pin 85) is a common ground...usually to your car metal. Remember how the coil is pin 86 and 85...if the common ground is always hooked up to the relay (coil) but the accessory line (pin 86) only receives a + signal when the car is on..then that is self explanitory that the relay will be energized only when the car is running or in 'accessory mode'.

Cause we got that far, now we need to look at how to power the inverter through the relay. You have a positiive a negative wire on the inverter so you'll first want to hook up the negative input to a common ground ..again your car metal.  The positive input wire now needs to hook up on pin 87 of the relay. [Remember pin 87 is normally open (NO)]

Last but not least..how the hell does the inverter get the positive (+) it needs? Simple!..hook up a wire going directly to a 12v+ source (the car battery is your best bet)  to the common pin on the relay (pin 30).

Thats it! Now, when you turn on your car the relay will be energized and send that positive signal from the battery (pin 30) to the positive input on the inverter (pin 87).  WHALLA! The device you are looking for!

I hope this helps you understand a standard 5 pin relay better and how the inverter will only turn on with the car being powered;  Cause I know I sure as hell got cramps from writing so much..hehe..take care!

P.S. I never had an inverter in my car..i just made the diagram after you posted the question.

(Also, i edited one of my posts so the image doesnt show twice because the server is back up Yay! )

Certainly!! I am always glad to help out when i can!...(which is usually never  cause I'm the one asking questions.hehe) You all take care.

So sparkyssb, You work for eriecoast???

JT (formerly of Micro Advantage)