
2007 chevrolet colorado, remote start wiring
Welcome Guest :)
jnjm2003
Member -
Posts: 8
Joined: October 03, 2005
Posted: January 06, 2009 at 7:59 AM / IP Logged
I am looking for remote start info for 2007 Chevrolet Colorado.
ckeeler
Gold -
Posts: 1,461
Joined: June 20, 2008
Location: New Mexico, United States
Posted: January 06, 2009 at 3:07 PM / IP Logged
use the XK06 module for this install. 12 VOLT CONSTANT | GET 12VOLTS FROM VHICLES BATTERY ONLY | @ BATTERY ONLY | |
STARTER | not used! | See NOTE *1 | |
STARTER 2 | N/A | | |
IGNITION 1 | WHITE/ GREEN to DARK BLUE (+) | IGNITION SWITCH HARNESS | |
IGNITION 2 | See NOTE *1 | | |
IGNITION 3 | N/A | | |
ACCESSORY /HEATER BLOWER 1 | WHITE/ RED to BROWN (+) | IGNITION SWITCH HARNESS | |
ACCESSORY /HEATER BLOWER 2 | N/A | | |
KEYSENSE | N/A | | |
PARKING LIGHTS ( - ) | BROWN / WHITE (-) | @ BCM, GRAY Plug, Pin A7, See NOTE *4 | |
PARKING LIGHTS ( + ) | BROWN (+) | @ BCM, BLACK Plug, Pin A48, See NOTE *4 | |
POWER LOCK | LIGHT BLUE (TYPE B) | @ BCM, BLACK Plug, Pin A11, See NOTE *4 | |
POWER UNLOCK | DARK BLUE (TYPE B) | @ BCM, BLACK Plug, See NOTE *4 | |
LOCK MOTOR WIRE | GRAY (+) | @ DOOR LOCK SWITCH in DRIVERS DOOR | |
DOOR TRIGGER | See NOTE *2 | See DIAGRAM | |
DOMELIGHT SUPERVISION | WHITE to DARK GREEN / WHITE (-) | @ BCM, BLACK Plug, Pin A46, See NOTE *4 | |
TRUNK RELEASE | N/A | | |
SLIDING POWER DOOR | N/A | | |
HORN | GREEN to BLACK (-) | @ BCM, GRAY plug, Pin A25, See NOTE *4 | |
TACH | ANY wire that is NOT PINK or BLACK | @ any IGNITION COIL or FUEL INJECTOR | |
WAIT TO START LIGHT | | | |
BRAKE | LIGHT BLUE (+) | @ STEERING COLUMN HARNESS | |
FACTORY ALARM DISARM | N/A | | |
ANTI-THEFT | GM'S NEW PASSLOCK 2 ANTI-THEFT System | | |
NOTES |
NOTE *1 This vehicle requires a special PASSLOCK 2 Bypass module Part #XK06 or PLJX NOTE *2 This vehicle has (4) door trigger wires the GREY/BLACK (-) is used for the DRIVERS door Pin A32, the PASSENGER door is a LIGHT GREEN/ BLACK (-) Pin A38, the DRIVERS REAR door is a LIGHT BLUE/BLACK (-) Pin A39 and the PASSENGERS REAR door is a BLACK/ WHITE (-) Pin A39 all are located at the BCM's BLACK Plug. When connecting to an ALARM SYSTEM use all 4 and DIODE ISOLATE. NOTE *4 the BCM is located in the PASSENGER KICK PANEL. |
jnjm2003
Member -
Posts: 8
Joined: October 03, 2005
Posted: January 25, 2009 at 11:07 AM / IP Logged
Where is the black plug for the XK06 data wires to go into? It has the connector in the XK06 instructions, but I can't seem to find this connector.
Follow the12volt.com
Monday, May 12, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.