
2005 Toyota 4runner SE alarm w/r start
Welcome Guest :)
DevineT4R
Member -
Posts: 5
Joined: February 03, 2005
Location: United States
Posted: February 03, 2005 at 1:38 AM / IP Logged
I need a 2005 Toyota 4Runner Wiring diagram to install a Compustar Alarm w/ remote start.
jandjav
Member -
Posts: 13
Joined: October 28, 2004
Posted: February 05, 2005 at 12:47 AM / IP Logged
| MODEL | YEAR(S) |
| 4-RUNNER | 2005 - |
| KEY | T-HARNESS | IMMOBILIZER |
| N/A | N/A | 791 BYPASS MODULE and EXTRA IGNITION KEY |
| PART | COLOR | LOCATION | DIAGRAM |
| 12 VOLT CONSTANT | WHITE/ BLUE and RED (+) | IGNITION SWITCH HARNESS | |
| STARTER | GREEN/ BLACK (+) | IGNITION SWITCH HARNESS | |
| STARTER 2 | N/A | | |
| IGNITION 1 | BLACK/ RED (+) | IGNITION SWITCH HARNESS | |
| IGNITION 2 | BLUE / YELLOW (+) | IGNITION SWITCH HARNESS | |
| IGNITION 3 | N/A | | |
| ACCESSORY /HEATER BLOWER 1 | WHITE/ GREEN (+) | IGNITION SWITCH HARNESS | |
| ACCESSORY /HEATER BLOWER 2 | N/A | | |
| KEYSENSE | GREEN/ YELLOW (-) | IGNITION SWITCH HARNESS | |
| PARKING LIGHTS ( - ) | GREEN (-) | @ BECU, TOP PLUG PIN 8 See NOTE *1 | |
| PARKING LIGHTS ( + ) | GREEN (+) | LEFT of FUSES, 16-PIN Plug | |
| POWER LOCK | BLUE | IN DRIVERS KICK PANEL, 18-PIN Plug (TYPE B) | |
| POWER UNLOCK | GREEN (DOUBLE PULSE) | IN DRIVERS KICK PANEL, 18-PIN Plug (TYPE B) | |
| DOOR TRIGGER | PURPLE / YELLOW (-) | @ BECU, TOP Plug, PIN 12 See NOTE *1 | |
| DOMELIGHT SUPERVISION | WHITE (-) | @ Plug to the RIGHT of the FUSES, Pin 8 | |
| TRUNK RELEASE | N/A | | |
| SLIDING POWER DOOR | N/A | | |
| HORN | GREEN/ RED (-) | @ HORN SWITCH | |
| TACH | BLACK/ WHITE | @ ECM BEHIND GLOVEBOX See NOTE *2 | |
| WAIT TO START LIGHT | N/A | | |
| BRAKE | GREEN/ YELLOW (+) | LEFT of FUSES, 16-Pin Plug | |
| FACTORY ALARM DISARM | DISARMS with KEYSENSE wire | | |
| ANTI-THEFT | TRANSPONDER | @ IGNITION SWITCH TUMBLER | |
| EXTRA INFORMATION |
| NOTE *1 the BECU is part of the FUSE/RELAY BOX under the DRIVERS SIDE of the DASH. the unit has 3 Plugs on the RIGHT SIDE of the FUSE BOX, these are the BECU harnesses. NOTE *2 on 6 Cylinder vehicles, it is the second plug from the bottom, Pin 1, or at the DATA LINK Connector under the drivers side of the dash,and on the V-8, it is in the bottom plug, Pin 5. |
| LINK 1 | LINK TEXT 1 | LINK 2 | LINK TEXT 2 |
| | | | |
Follow the12volt.com
Wednesday, November 5, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.