2003 Nissan Sentra, Remote Start Wiring
Welcome Guest :)
chiarlanza
Member -
Posts: 30
Joined: January 17, 2005
Location: United States
Posted: January 21, 2007 at 12:26 PM / IP Logged
Looking for the specs to install a remote start on an 03 Nissan Sentra.
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: January 24, 2007 at 8:16 AM / IP Logged
| PART | COLOR | LOCATION |
| 12 VOLT CONSTANT | WHITE/ RED (+) | IGNITION SWITCH HARNESS |
| STARTER | BLACK/ WHITE (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| STARTER 2 | BLACK / YELLOW (+) See NOTE *1 | IGNITION SWITCH HARNESS |
| IGNITION 1 | BLACK/ RED (+) | IGNITION SWITCH HARNESS |
| IGNITION 2 | N/A | |
| IGNITION 3 | N/A | |
| ACCESSORY /HEATER BLOWER 1 | WHITE (+) | IGNITION SWITCH HARNESS |
| ACCESSORY /HEATER BLOWER 2 | WHITE/ BLUE (+) | IGNITION SWITCH HARNESS |
| KEYSENSE | N/A | |
| PARKING LIGHTS ( - ) | N/A | |
| PARKING LIGHTS ( + ) | WHITE/ RED (+) or RED / BLUE (+) | IN DRIVERS KICK PANEL or HEADLIGHT SWITCH |
| POWER LOCK | GRAY (TYPE B) | @ SECU, See NOTE *2 |
| POWER UNLOCK | PURPLE / RED (TYPE B) | @ SECU, See NOTE *2 |
| DOOR TRIGGER | See NOTE *3 | @ SECU, See NOTE *2 |
| DOMELIGHT SUPERVISION | RED / YELLOW (-) | @ SECU, PIN 8, See NOTE *2 |
| TRUNK RELEASE | RED (-) | @ HATCH RELEASE SWITCH |
| SLIDING POWER DOOR | N/A | |
| HORN | WHITE/ GREEN (-) | @ STEERING COLUMN HARNESS |
| TACH | ANY WIRE BLACK/ RED, PURPLE, BLUE/RED or GRAY/RED | @ ANY IGNITION COIL |
| WAIT TO START LIGHT | N/A | |
| BRAKE | RED / GREEN (+) | @ SWITCH ABOVE BRAKE PEDAL |
| FACTORY ALARM DISARM | WHITE/ BLUE(-) | @ SECU, PIN 30, See NOTE *2 |
| ANTI-THEFT | TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY | TRANSPONDER @ IGNITION SWITCH TUMBLER |
| EXTRA INFORMATION |
| NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 THE SECU (Security Electronic Control Unit) IS LOCATED TO THE RIGHT OF STEERING COLUMN. NOTE *3 ON VEHICLES WITHOUT POWER DOORLOCKS USE RED / WHITE (-) IN DRIVERS KICK PANEL. ON VEHICLES WITH POWER DOORLOCKS, USE RED (-) FOR DRIVERS DOOR AND RED / WHITE (-) FOR PASSENGER DOOR, WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM |
Follow the12volt.com
Thursday, May 1, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
