alarm wiring for 2006 vw passat
Welcome Guest :)
kiteman
Copper -
Posts: 98
Joined: January 14, 2004
Location: United States
Posted: August 19, 2007 at 11:45 AM / IP Logged
I'm in need of the wiring info for a 2006 vw passat. The only info I can find is on a 2004 and that info doesn't even come close. I pretty much found everything but the parking light and the door trigger and the door locks.
KarTuneMan
Platinum -
Posts: 7,056
Joined: December 14, 2004
Location: Isle Of Man
Posted: August 19, 2007 at 12:06 PM / IP Logged
| PASSIVE ANTI-THEFT | YES | TRANSPONDER (Bypass or Data module required) | SEE NOTES |
| | | This vehicle is equipped with an IMMOBILIZER passive anti-theft system. Please refer to the diagram for proper bypass instructions. |
|
| 12 VOLTS | Red | Behind the fusebox on the left side of the dash | + |
| IGNITION | RED / blue | Pin-4 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| IGNITION 2 | GREEN/ gray & Green | Pin-12 and Pin-1 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| STARTER | RED / gray | Pin-3 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| STARTER 2 | RED / gray | Pin-11 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| KEY SENSE | Green | Pin-1 on Ignition switch connector | + |
| | | This wire is required for remote start and should be energized before ignition. |
|
| LOCK | White (1-3) | At module in driver's door | - |
| | | 1-wire system. Straight ground (-) to lock and ground through 180-ohm resistor to unlock. |
|
| UNLOCK | White (1-3) | At module in driver's door | - |
| | | 1-wire system. Straight ground (-) to lock and ground through 180-ohm resistor to unlock. |
|
| TRUNK RELEASE | GREEN/ black | In driver's door at switch | - |
| FACTORY ARM | Arms with lock | | |
| FACTORY DISARM | Through OEM remote only | | |
| | | Alarm will disarm automatically on remote start when the transponder is detected. |
|
| BRAKESWITCH | RED / black | In the driver's kickpanel | + |
| PARKLIGHTS | RED / blue & WHITE/ black | At the lightswtch in the dash | |
| | | This requires so special wiring, please refer to the parklight diagram. |
|
Follow the12volt.com
Friday, May 9, 2025
• Copyright © 1999-2025 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
