cell hands free kit

Home / the12volt's Install Bay / Cellular and Communications / cell hands free kit (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

beancounter

Member - Posts: 1

Joined: January 16, 2004

Location: United States

Posted: January 16, 2004 at 10:38 PM / IP Logged

I have a 2002 300M and am trying to get the cellular phone hands free kit working correctly. The phone needs an accessoriy hook up (hot with ignition on) that stays hot during the start sequence. the current hook up goes down during the start sequence which allows the phone to come on only about half way (charge only)

The "professional" installer says the wiring diagram for this does not show an accessory hook up like this, the mechanic at the Chrysler garage says there should be one in the fuse box assembly under the hood.

Can anybody help me out, tell me where this "circuit" could be located.

Thanks

Dan

Teken

Gold - Posts: 1,492

Joined: August 04, 2002

Location: Aruba

Posted: January 16, 2004 at 11:52 PM / IP Logged

Chrysler

300M

1999-2002

Remote Starter Wiring Colors and Notes

Function

Vehicle Color

Location

Start:

YELLOW

IGNITION SWITCH HARNESS **

Ignition #1:

DK. BLUE/WHITE

IGNITION SWITCH HARNESS

Ignition #2:

DK. GREEN/ RED

IGNITION SWITCH HARNESS (TRANS.)

Ignition #3:

N/A

Accessory:

BLACK/ ORANGE

IGNITION SWITCH HARNESS (HEATER/AC)

Brake Light:

WHITE/ TAN

AT SWITCH ABOVE BRAKE PEDAL

Tach Signal:

TAN/PINK, TAN/LT. BLUE

TAN/RED, OR TAN/ORANGE AT PCM *

Parking Lights:

BLACK / YELLOW

# PIN CONN. IN DRIVER'S KICK PANEL

Headlights:

OEM Alarm Disarm:

LT. GREEN/ ORANGE (+)

DRIVER'S KICK PANEL*****

OEM Alarm Arm:

Diesel Glow Plug:

Clutch Bypass Wire:

Notes:

* Powertrainln Control Module (PCM) Is Located On Driver's Rear Of Engine Compartment In Fron Of Power Distribution Box. Each Wire Listed Is A Single Cylinder Signal. ** If The Key Is Gray, This Vehicle Is Equipped With Chrysler's New Smart Key Anti-Theft System. See Installation Note #144 - Bypassing Transponder Theft Systems.

--------------------------------------------------------------------------------

Chrysler

300M

1999-2002

Alarm and Keyless Entry Wiring Colors and Notes

Function

Vehicle Color

Location

Constant +12 Volts:
RED & PINK/BLACK
IGNITION SWITCH HARNESS

Starter Kill:

YELLOW

IGNITION SWITCH HARNESS **

Ignition +12 Volts:

DK. BLUE/WHITE

IGNITION SWITCH HARNESS

Dome Lights/Superv:

YELLOW (-)

AT BODY CONTROL MODULE ****

OEM Horn:

BLACK/ RED (-)

AT FUSE BLOCK IN DIRVER'S KICK PANEL

Power Lock:

WHITE/ LT. GREEN

# PIN CONN. IN DRIVER'S KICK PANEL***

Power Unlock:

SINGLE WIRE SYSTEM

# PIN CONN. IN DRIVER'S KICK PANEL***

Trunk Release:

BLACK/ WHITE (+)

AT TRUNK RELEASE SWITCH

Alarm Input Wire:

YELLOW (-)

AT BODY CONTROL MODULE ****

Notes:

*** Single Wire Door Lock System; See Note # 217 - Cirrus/Sebring/Stratus Single Wire Door Lock Diagram. **** Body Control Module Is Located A Junction Block Behind Driver's Dash. ***** Single Wire System A Positive Pulse Through A 1.75 K-Ohm Resistor Will Lock and Arm; A Positive Pulse Through A 680 Ohm Resistor. See Note #211

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You can vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

cell hands free kit

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.