Delayed HID start on my bike?

Home / the12volt's Install Bay / Lights, Neon, LEDs, HIDs / Delayed HID start on my bike? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

FACTION95Si

Member - Posts: 1

Joined: October 19, 2003

Location: United States

Posted: October 19, 2003 at 10:37 AM / IP Logged

I just installed an HID kit on my bike. Right now I have the low beam on a switch so I can start the bike then turn on the HID. If I start the bike while the HID is on its bad for the ballasts and it usually won't turn back on. So my question is there a way I can have the low beam turn on about 5 seconds after I turn my bike on? This will give me enough time to start the engine before the low beam turns on.

xetmes

Silver - Posts: 586

Joined: May 18, 2003

Posted: October 19, 2003 at 2:00 PM / IP Logged

of course there is a way... you could i would try to use a few resistors and a cap maybe a transistor or and SCR...

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Delayed HID start on my bike?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.