single cvr 10 wedge box design

I am trying to design a custom style wedge box to go in my 01 dodge ram 1500 single cab. I want to be able to keep the seat all the way back and would like to be able to continue to run my mono 6x9 in the rear. The sub I have that I would like to use a 07CVR 10 with 4ohm DVCs. This is what I have so far without performing any form of calculations. The internal volume including what is taken up by the sub itself is 1.493. I was going to port the box out the top of the large flat face. I am clueless when it comes to using the T/S parameters when designing a box and was hoping to get some in put from the experts. If i need to add volume to the box instead of having the large flat area i could mirror the wedge onto that side. The 6x9 is in its own sealed chamber. I am also not against having a sealed box if this would fit my size restraints better. Thanks Ray

Your volume looks good to fit the parameters of a vented box in the CVR10. You need to figure out where you want the box tuned at (most likely in the 30-35 Hz range). Then calculate the port size and length to get the box tuned at that frequency for your air space. Use the port length calculator on this site here: Port Calculator For example: To tune your box to 32 Hz, you could use a 2" diameter port tube that is 4.1" long.

Is a round port preferred to a slotted port. I was planning to do a slot up the end and out the top. Still playing with it though, i.e. adding volume to make up for the lost volume in the port and to add some bracing, at least in the tall corners and a couple along the bottom edge. Thanks for your input.

Some people have personal preferences for one or the other. Both can work well as long as they are setup correctly. Get your volumes calculated right and port sizes correct, you should be pleased either way.

Thanks again for your input. I decide to port out the side instead of the top to save on having to do an L-Port. Here is what I decided on. Now I just have to go hit up some friend(s) and see if I can use their table saw and router to get everything cut out. I wish I new someone who could do it for me but I guess that takes all of the fun out of it.

If I were you, I'd spare every last inch of airspace back there. The 6x9 is shooting you in the foot as far as the loudest, lowest bass sound. If the 6x9 is playing a true mono signal, then "to each his own"- i like it. As far as the box, large sealed enclosures sound decent with the CVR. Porting in that truck can potentially sound louder in the cab. Flip a coin~This is what I do for FUN!

There should be 2-3 inches between the port exit and the side of my truck. The volume should be pretty accurate because I modeled the box in SolidWorks. The volume should work out with 50 thousandths. I am not going for super loud, if I was I would use the dual 2ohm dvc cvrs I have or would use my 12s. The 6x9's single is a sum of the rear single before it hits my 4 channel amp. The only reason I used it is it was one of the 6x9s out of my doors, and I had no rears. I really dont like rear pillar speakers in single cab trucks. I may swap out the 6x9 for a semi-decent 6.5 or 5.23, havent decided yet.