port displcement

Home / the12volt's Install Bay / Car Audio / port displcement (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

gcorrea

Silver - Posts: 436

Joined: May 22, 2004

Location: United States

Posted: August 31, 2004 at 10:50 PM / IP Logged

does any one have the formula to calculate displacement for a round port.

gcorrea

chevyman26

Copper - Posts: 227

Joined: April 14, 2004

Location: United States

Posted: September 01, 2004 at 9:15 AM / IP Logged

On the left side of this page under "volume calculators" there is a calc. for tube or cylinder enclosures. Just enter 0 for the thickness if you are measuring the inside diam. of the port.

You'd better get me out of this lord... or else you'll have me to deal with. -- Hunter S. Thompson "F.A.L.I.L.V."

chevyman26

Copper - Posts: 227

Joined: April 14, 2004

Location: United States

Posted: September 01, 2004 at 9:22 AM / IP Logged

Might have misunderstood you there. If you want to figure out how much of the boxes airspace is being used up, measure the outside diam. and run the formula (call this x), then measure the inside diam. and run the formula (call this y), then subtract x - y, and that will give you how much airspace the tubewalls take up.

You'd better get me out of this lord... or else you'll have me to deal with. -- Hunter S. Thompson "F.A.L.I.L.V."

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

port displcement

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.