Posted: November 11, 2005 at 2:59 PM / IP Logged
Posted: November 11, 2005 at 9:30 PM / IP Logged
Sorry, you can NOT post a reply.
This topic is closed.
Printable version

| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com
Sunday, November 9, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Sunday, November 9, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.




First, i will be running Rear and Front outputs into the Infinity amp, and run 4 speakrs from that (2 components in front door[150rms @4oh], and 2 6x9's in the back[100rms @4ohm])..as marked in red on diagram.Second, subwoofer outputs will be connected to mtx amp, and eventually into 2 12" Polko Momo mm12 subs (500 rms/each).. 800+rms produced by the mtx should be just enough.Now my questions are, how/where do i connect 2 remote leads into the head unit? i have one already that connects the mtx amp, where do i connect the Infinity remote lead into the head unit? I have provided the diagram of my head unit, as you can see, there are a couple of pins which are not being used.Also, i want to run 2 more sets of components in my rear door, but i don't want to buy another amp, these are infiity 6010cs (270watts, 90rms). I don't care if i can't get the most out of them, as long as they produce some sound. Is it possible to bridge any of the speaker outputs in the power supply of the head unit, so i can connect these and get more than 20watts to each speaker?Lastly, i have 1 farad Rockford fosgate cap, which i'll probably connect to the mtx....should i buy another for the mtx (i.e. 2 farad) and use this one for the infinity amp....is it necessary?





