Posted: September 26, 2006 at 2:40 AM / IP Logged
Posted: September 26, 2006 at 1:02 PM / IP Logged
Posted: September 26, 2006 at 1:05 PM / IP Logged
Posted: September 27, 2006 at 6:00 PM / IP Logged
Posted: September 27, 2006 at 10:55 PM / IP Logged
Sorry, you can NOT post a reply.
This topic is closed.
Printable version

| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Follow the12volt.com
Wednesday, October 29, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Wednesday, October 29, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.





The new style units look like these and says it works on 2004 to 2006 Chrysler vehicles.
Well here comes the question that I'm hoping you pros would have experience with. I was figuring on buying these two items and just plugging it all in. Then I read a note in one of the ebay auctions that states the following....
Notice the 22 pin connector on this unit's
back; It uses the NEW CAN bus system,
and is NOT compatible with older vehicles.
The other 10 pin connector, is for:
Rear Entertainment system or Satelite Radio Tuner.
So my question is... Will this adapter really work or is the CAN-BUS system not compatible with this kind of set-up on newer vehicles? Or do you think he may have just been saying that it won't plug right in to older vehicles.(due to the connectors being completely different)
If they are not compatible using this adapter harness is there an Affordable Solution to making this setup work like I had hoped? Perhaps some kind of CAN-BUS adapter from PAC?
Thanks for any knowledge or advice you can provide. Steve





