2010 mazda 3 no crank

Hey all. I installed a Autostart 2371-tw-fm into a Mazda 3 (Manual). I am running a ADS-TB with FM-2 firmware for the bypass. I cannot get the unit to crank. I can arm it and remove the key and it continues to run, shut it down. But when I try to start it, it seems like it tries to start but doesn't crank. It then gives me 3 flashes. Which appears to be a VTS / tach fail. Any ideas? I am lost on this one.

A couple of thoughts... 1. Clutch bypass? 2. I'm not familiar with Autostart units, but do they require running in Tach Mode for manual transmission vehicles? If yes, did you get a successful tach learn? 3. Did the ADS TB FM2 program as per the install guide? Might try a remote start while depressing the clutch pedal. Might try a remote start with the power disconnect to the ADS TB and a working key in the ignition switch - not turned.Soldering is fun!

You hit it right on the head. It was the clutch bypass. That's what I get for being lazy. I did a Mazda before that had a positive clutch bypass, but this was negative. Rookie mistake.... No clutch, no crank. Thanks!