2003 Dodge Caravan SE

listen if you have never done this car before take it somewhere. reason 1 there is a second starter wire. which is negative and requires a 180 ohm resistor and isolated with a relay. 2 each door has its own trigger wire so that means you most likely have six doors that have to be diode isolated. 3 the parking lights have to be negative through a 2.1k ohm resistor ., and another relay has to be used., 4 the constants at the key cylander are only ten amps so that means you have to go to the battery to get power. 5 yes the door locks are one wire (PURPLE / green at the bcm. and ther resistance is 5.3k ohm for lock and 2.okohm for unlock you must use relays, to isolate,. 6 the trunk hatch pin has to be diode isolated from the bcm to avoid parking lights and domelight problems., this is a hard hard car to do alot is required to do it., if you are not expereienced dont mess with it. this car is also a baby it does not like to be played with by adults. only babies(experienced installers)Jon

Installer/Help Technician

---coral springs florida---

mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.