problem finding door pin wire

Home / the12volt's Install Bay / Car Security and Convenience / problem finding door pin wire (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bdog

Member - Posts: 5

Joined: July 26, 2003

Posted: July 26, 2003 at 4:05 PM / IP Logged

I am working on installing an alarm in a 2001 Dodge Ram 2500 diesel. The wiring diagrams I have say there are seperate wires for each door, a tan one for the driver and a BLACK/ blue for the passenger. They also say both are located at the module on the right side of the steering column. I found the module (the annoying beeping one) and the tan wire is present and is the door pin for the driver door. However there is no BLACK/ blue wire present and I put the meter on all the other wires and none of them are the passenger door pin. Also I notice the beeping noise you get when a door is open is only occurs when the driver door is open and not when the passenger door is open. Any ideas?

tjdurham

Copper - Posts: 180

Joined: July 25, 2003

Location: United States

Posted: July 26, 2003 at 7:49 PM / IP Logged

try a yellow wire in a whit plug in drivers kick panel *it may have a delay

tjdurham

Copper - Posts: 180

Joined: July 25, 2003

Location: United States

Posted: July 26, 2003 at 7:50 PM / IP Logged

try a yellow wire in a white connector in drivers kick panel it controls both doors *it may have a delay

bdog

Member - Posts: 5

Joined: July 26, 2003

Posted: July 26, 2003 at 8:07 PM / IP Logged

Thanks. I will try it. I just finished get everything else hooked up. This was my first alarm install and from the knowledge I gained on this site it went smoothly and everything worked(remote start, keyless entry, etc.) Only problem I had and it was a stupid mistake but my alarm came with a prewired relay for the starter kill. I wired up the relay and tried remote start it worked but when I retried with the key it would not crank. After about 30 minutes checking wires I realized that even though I had wired up the plug for the relay I forgot to plug the relay in.

bdog

Member - Posts: 5

Joined: July 26, 2003

Posted: July 26, 2003 at 9:50 PM / IP Logged

The yellow wire did the trick. Install is complete. Thanks again.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

problem finding door pin wire

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.