help with 530t

alright i been working on this for about 6 hours yesterday...i pretty sure that hooked up everything right  but here we go....

i have a 94 integra RS with power windows but no power locks

while driver and passenger windows are down, i push the AUX channel on my alarm...passender winow rolls all the way up, and driver does nothing

while windows are up, push aux, my driver window goes like 2 inches then stop passenger windows does nothing. i have to keep on pushing the AUX button atleast 4-5 times to get my driver window to go all they way down.

if i'm in the car the "one touch function on the driver side no longer works but if i push it it goes and stops like 2 inches each time.

passenger window now has "one touch"

so both windows work at the switch....

i was reading on the manual and it say "if the driver has 'one touch' feature interface at motor not switch, would anyone happen to know more about the relay and where it is, i looked and the thick wires just come out from the switch and directly into the motor.

heres a diagram that i drew up(1:30am) so sorry if hard i suck at drawing.,

http://www.imagestation.com/picture/...

the wires are tap together with the 'thread and needle' idea and tie wraped around, with 12 gauge wire running into the the door thru the molex connector, so again. i'm pretty sure on my connections.

EDIT: the alarm is hooked up to clifford ARROW 2 alarm, i dont know if that will help or not, but any help will be greatly appreciated

well, if i hooked it up wrong like you said, would it still go work properaly from the driver switch?

and i was checking if there was voltage coming out of the (-)arm wire and for some reason there is 5 volts coming out from this wire, would i need a diode to stop this current to show only negative out to the starter kill relay(might be feedback or something like that)...

ps. i took out the module today and i'll try doing again tomorrow b/c this morning i couldnt roll down my windows(weird)

i would be using the last diode right?