Installing Hornet 553T

When failsafe starter kill is used, where does the starter circuit output wire attach to. Does it connect together with the wire comming from the starter kill relay out to the starter? Does anyone have a diagram of how to wire this relay, I have done it before, but Im not sure if it was done correctly.Also should my relays have diodes between the pos and neg poles of the coil? Thanks Alan

Green goes to switch side of starter wire (you will have to cut this wire) Black goes to starter side of starter wire Yellow goes to ignition Orange should already be connected to the negitive when armed wire from the alarm if it is not, then connect it to the orange wire from the main harnessRemember check all your wires with a DMM!

yes to the above question. I usually attach the starter kill relay to the main relay pack to make one big relay pack. Then you can connect the yellow from the starter kill relay to the thick pink wire in the relay pack, the thick black to the thick purple, and the thick green gets extended and gets run with the other wires to the ignition harness. Cut the starter wire....purple to starter side.....green to key side.