2003 camry unlock

I installed an Autopage rf-410 into a 2003 camry le with factory keless entry and trunk. the alarm unlock (-) was attached to the (-) blue in dkp. When the doors are remotely unlocked the drivers door will unlock, then approx 2 seconds pass and the rest of the doors will unlock... does this happen because I have not programmed the alarm for a double pulse? I have also not connected the alarm unlock to the child safety lock wire. The color for this wire is supposed to be blue/red.. but the only blue/red I can find is for the door lock motor? Does the child safety lock wire need to be connected? if so where is it and what color? Is there a way to get the drivers door to open on the first push of the unlock button and then the rest of the doors on the second push similar to the factory keyless entry? Thanks. Rod

Make:   Toyota Model: Camry Year:    2003 This Database Was Last Updated On:    6/9/03 Index #: 885 Alarm Constant 12 volts WHITE/ RED OR WHITE IGNITION SWITCH HARNESS Ignition 12 volts BLACK/ RED IGNITION SWITCH HARNESS Starter BLACK / YELLOW AND BLACK /WHITE AT IGNITION SWITCH HARNESS * Dome Light GREEN/ RED (-) IGNITION KEY CYLINDER LIGHT Trunk Pin Switch GREEN / WHITE (-) AT THEFT DETERRENT E.C.U. ** Parking Lamp GREEN (+) AT THE BACK SIDE OF E.C.M.*** Power Lock BLUE / YELLOW 13 PIN GRAY CONN. IN DR KICK Power Unlock BLUE 20 PIN WHITE CONN.IN DR KICK **** * There Are Two BLACK / YELLOW Wires Please Check. ** Theft Deterrent E.C.U. Is Located Behind Pass Side Dash Top Right. *** E.C.M. Located Above Drivers Kick Panel A Part Of Fuse Box. **** First Pulse Unlocks Driver 2nd Pulse Unlocks The Rest. #201 - See Negative Pulse Door Lock DiagramGood Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

"Is there a way to get the drivers door to open on the first push of the unlock button and then the rest of the doors on the second push similar to the factory keyless entry? " Does your autopage unit have a driver door priority output? If so you'd want to use a relay on the blue/black driver door wire (have to cut it) to do the driver door first and then your unlock wire to the blue wire. Wiring in DDP also takes care of the child safety so you won't have to worry about that. Edit: Ok I was being lazy here's how you would hook up the relay.. 85 - To (-) driver door priority output 86 - 12v constant fused 87a - to switch side of cut blue/black wire 30 - to motor side of cut blue/black wire 87 - to 12v constant fused Good luck, Mike