99 subaru legacy remote start

Home / the12volt's Install Bay / Car Security and Convenience / 99 subaru legacy remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

trucknutz

Member - Posts: 1

Joined: January 04, 2004

Posted: January 04, 2004 at 10:32 PM / IP Logged

I've recently purchased a ratter keyless entry and remote start, the keyless entry is working, however, the starter only bumps over, maybe one time. I've tried to program the module for a longer crank time, but it doesn't seem to do anything. This unit is suposed to recognize engine voltage, thus making a tach hook-up wire unnecessary. I've tried with a tach wire, on each of the four wires at the coil, and without. Any ideas, HELP!!!!

gardnerb1

Member - Posts: 3

Joined: January 05, 2004

Location: United States

Posted: January 05, 2004 at 8:26 AM / IP Logged

Well its always difficult to troubleshoot without looking at the vehicle, but a couple ideas. First off I don't believe the subaru has any factory anti-theft systems. So that being said, I would go straight to the ignition harness and verify that the wires are getting what they need for the vehicle to start. i.e. ign, accsy, etc. Also make sure that you dont need a 2nd ign or 2nd accessory to be energized in order to start. (i havent done a remote start on a subaru in awhile)

You are correct that you can use voltage sense on the Rattler's. Although you may want to check what the default setting is in programming options. i.e. tach or voltage. There is also an option for voltage threshold which may need to be changed in order for the remote start to recognize the status of the vehicle's engine.

Good luck,

ps DEI's tech line is great help...if you can wait on hold for awhile to get thru

I just saved a ton on my car insurance! 99 subaru legacy remote start -- posted image.

draasch

Gold - Posts: 2,172

Joined: February 07, 2003

Location: Florida, United States

Posted: January 05, 2004 at 8:40 AM / IP Logged

double check your hook ups...this all i have....

Make: Subaru

Model: Legacy

Year: 1999-00

This Database Was Last Updated On: 6/9/2003

Index #: 3441

Alarm

Constant 12 volts BLACK / YELLOW IGNITION SWITCH HARNESS

Ignition 12 volts RED IGNITION SWITCH HARNESS

Starter BLUE/RED IGNITION SWITCH HARNESS

Dome Light RED / WHITE (-) *AT KEYLESS ENTRY MODULE

Trunk Pin Switch YELLOW/BLACK (-) *AT KEYLESS ENTRY MODULE

Parking Lamp L:RED / GRAY R:RED / GRAY BEHIND FUSE BOX 12-PIN AND 10-PIN CON

Power Lock WHITE/ RED (-) DRIVERS KICK PANEL 24-PIN CONN. #201

Power Unlock WHITE (-) DRIVERS KICK PANEL 24-PIN CONN.

*Keyless entry module located under drivers dash left side of steering column #201- See Negative Pulse Door Lock Circuit Diagram

Remote Start

Tach Signal RED / GREEN AT COIL

Ignition #2 NA

Ignition #3 NA

Accessory RED / YELLOW IGNITION SWITCH HARNESS

Neutral Safety RED / YELLOW ON TOP OF TRANSMISSION

Brake Light WHITE/ BLACK AT SWITCH

Reverse Light NA

Rear Window Defrost NA

To Do Ignition Bypass On The Factory Keyless And The Security System: GREEN / WHITE:Keyless Above Right Passigner Kick Panel. GREEN / WHITE:Security System Next To Radio

Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

99 subaru legacy remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.