2001 Ford Windstar door lock pulse?forRS

   I am installing a Crimestopper RS901 remote start in the van.  I got it all hooked up but I can't find a neg pulse to activate the starter off the factory remotes.  My diagram says LT blue/orange at FEM i checked it no pulse.  I checked that wire at the door lock switch and it has the pulse there only when you hit the button on the door not with the remotes.  If I take the activation wire and ground it the van starts and runs fine but I need to figure out how to give it a pulse through the remotes.  Thanks...Mike

see if this will help you.......... program the RS to start on a double pulse from the door lock.... Power Unlock L GREEN/ YELLOW ELECTRONIC MODULE *** *** F.E.M.Is Behind Driver's Dash Panel. #201 - See Negative Pulse Door Lock Diagram. Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

 I only have the option of a single pulse or 3 pulses on the RS unit.  you say the LGREEN/ YELLOW wire will give me a double pulse may be I will have to hit the lock button twice that will give it one extra pulse but should still work.  This wire is in the FEM can I probe it at the FEM plug to check for the pulse?  Is there a wire like this for the lock side so I can lock the doors when it starts.  Thanks..Mike

i posted the wrong color..... Power Lock L BLUE/ORANGE 20 PIN CONNECTOR AT FRONT ELECTRONIC MODULE *** *** F.E.M.Is Behind Driver's Dash Panel it will give you one pulse for each time you push the lock button on the transmitter.....Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt