passlock 2 problem

Home / the12volt's Install Bay / Car Security and Convenience / passlock 2 problem (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

larkster

Copper - Posts: 98

Joined: October 04, 2003

Location: Canada

Posted: February 18, 2004 at 6:35 PM / IP Logged

had a car towed in to the shop today. with a no start problem. i traced it to the passlock system it has a viper remote start in it. with a 555lw. what i have found is that the cars black passlock wire has no ground on it. does anybody know if it is grounded through the ignition switch or from a different source. thanks in advance.

sparkie

Platinum - Posts: 2,061

Joined: November 06, 2003

Location: Canada

Posted: February 18, 2004 at 6:45 PM / IP Logged

The Passlock wires usually come from the BCM in most GM's. It is not a true ground but a low reference for the Passlock system. Disconnect your interface and get the vehicle running properly. Then, if no problems exist try your bypass again. It or it's connections may be at fault.

sparky

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

passlock 2 problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.