Plymouth Grand Voyager remote start

Home / the12volt's Install Bay / Car Security and Convenience / Plymouth Grand Voyager remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

videoviking

Member - Posts: 15

Joined: February 16, 2004

Location: United States

Posted: September 11, 2004 at 8:08 AM / IP Logged

Okay all you installers out there, please help me out. I have a Plymouth Grtand Voyager witht he 3.3L V-6. These motors have a coil pack that each wire shows less than the 12v a typical coil would show upon start. What have you done to get a tach signal in these vans to show up on the tach sensing wire for a remote start?

Chuck Johnston

tbirdman74

Copper - Posts: 164

Joined: August 22, 2003

Location: United States

Posted: September 11, 2004 at 9:31 AM / IP Logged

What year?

Remember the Heroes. Let's Roll.

If it don't fit, Force it.

If it breaks, You needed a new one anyway!

videoviking

Member - Posts: 15

Joined: February 16, 2004

Location: United States

Posted: September 11, 2004 at 9:52 AM / IP Logged

1992 Grand Voyager with all the options except leather

Chuck Johnston

tbirdman74

Copper - Posts: 164

Joined: August 22, 2003

Location: United States

Posted: September 11, 2004 at 10:29 AM / IP Logged

3.3L & 3.8L Engine Have 3 Coils. Wire Colors At Coils Are BLACK/ GRAY, RED / YELLOW & DK. BLUE / YELLOW, Each Wire Is A 2 Cylinder Signal. Wire Colors Also Found At Engine Control Module In Engine Compartment On Driver Fenderwell.

Remember the Heroes. Let's Roll.

If it don't fit, Force it.

If it breaks, You needed a new one anyway!

videoviking

Member - Posts: 15

Joined: February 16, 2004

Location: United States

Posted: September 11, 2004 at 3:07 PM / IP Logged

so, do I make a three wire harness and attach to all three coils, or could I just take the wire from the tach (not sure where that is located) and splice in?

Chuck Johnston

tbirdman74

Copper - Posts: 164

Joined: August 22, 2003

Location: United States

Posted: September 11, 2004 at 6:41 PM / IP Logged

Label coils 1 thru 3, then randomly pick a number between one and three. Use corresponding coil. Doesn't matter which one.

Remember the Heroes. Let's Roll.

If it don't fit, Force it.

If it breaks, You needed a new one anyway!

xtremeaudio

Copper - Posts: 174

Joined: August 30, 2004

Location: United States

Posted: September 14, 2004 at 4:04 AM / IP Logged

can't find tach wire use fuel injecter wire they are the same atlist they have 6 wire more easy to find

videoviking

Member - Posts: 15

Joined: February 16, 2004

Location: United States

Posted: September 19, 2004 at 7:45 PM / IP Logged

has anybody done a remote start on this vehicle and can pass on the wiring diagram?

Chuck Johnston

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Plymouth Grand Voyager remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.