Problem with Jeep Grand Cherokee

Ok. Installing a Autostart 2way system in my jeep 2001-grand cherokee

Problem: When I connect the main wiring harness to the autostart brain the car starts to crank over. So I have to immediatly remove it.

Here is how the wires are hooked up

Main Harness:

A=12 volt=Red

B=Starter Output=Yellow

C=12volt=pink black

D=Ignition=Yellow

E=accessory=Dark blue

I know your supposto test each wire before you connect it, the only problem is this is a grand cherokee, and everyone who has installed those, knows they cant get access to the ignition harness so you can disconnect the harness and let it fall and then you have access to all the wires. So I tested both 12V wires, they turned out fine, but the starter, ignition and accessory wire you cant test because they are not connected to vehicles column.

Here is the wires so you can confirm that they are connected correctly. https://www.the12volt.com/installbay/forum_posts.asp?tid=43867&KW=grand+cherokee

Here is how the wires are hooked up

Main Harness:

A=12 volt=Red

B=Starter Output=Yellow  * You may have your Yellows switched. Did you verify first?

C=12volt=pink black

D=Ignition=Yellow     * I have DARK BLUE as Ignition 1

E=accessory=Dark blue  * I have RED / Black as Acces.

__________________________________________________________________________

* CAUTION!! This Vehicle Uses A Data Link Circuit For Power Windows. Colors Listed For The Driver Front Are Located At Switch In Driver Front Door. Colors Listed For Other Doors Are Located At Switches In Each Door. For Front Windows, - Reversal Rest At Ground Circuit, For Rear Windows - Reversal Rest At Positive Circuit.

* TAN/PINK Is A 2 Cylinder Signal With A 4.0L Engine Or A 1 Cylinder Signal With A 4.7L Engine. Located In The White Connector Pin #9. ** Powertrain Control Module (PCM) Is Located Passenger Rear Of Engine Compartment. Immobilizer Bypass

I actually have  a test light, I used it on the 12 volt wires, but like the starter wire won't show a signal because its not hooked up to anything, its just hanging there.

Basically my problem was getting to the harness so I just pulled it out of its socket. How do I get to it? Do you need to remove a panel or a few screws? I tried to break it apart but couldnt get any of the plastic panels off to get access to the harness. I even unscrewed the screw that can be seen once you open the door (just below the side view mirror on the inside).

Thanks for the help, but our wiring sheets don't seem to match, why would mine say there is no second ignition wire while yours does?