Remote Start for 93 Explorer XLT

Home / the12volt's Install Bay / Car Security and Convenience / Remote Start for 93 Explorer XLT (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Lordmarcus42

Member - Posts: 4

Joined: January 02, 2005

Location: Canada

Posted: January 02, 2005 at 3:51 PM / IP Logged

I'm installing a Polarstart EX-2520TW (aka: Autostart AS-2520TW)Remote Starter into my 93 Ford Explorer XLT (w/o factory keyless)and just want to check 2 things before I hook up the "crank/starter" wire:

1) I noticed that when the ignition switch is in the "run" position, there is a constant 5V going down the "starter" (RED / Light Blue) wire and 12V when the ignition is in the "start/crank" position. Do I need a diode or relay between the vehicle's harness wire(RED / Light Blue) and the remote starter wire (6Pin Harness Purple wire) to prevent the constant 5V from feeding back into the remote starter and causing damage to it? And...

2) Do I need a 40A relay between the vehicle's 2nd Ignition wire (BLACK/ Green) and the Remote Starter's wire (6pin Harness Green wire)?

Thanks in Advance,

Marcus.

Craig3708

Copper - Posts: 155

Joined: January 30, 2004

Location: Canada

Posted: January 02, 2005 at 7:25 PM / IP Logged

No to both questions....

Ford

Explorer

1992-1994

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	RED / LIGHT BLUE	IGNITION SWITCH HARNESS
Ignition #1:	RED / LIGHT GREEN	IGNITION SWITCH HARNESS
Ignition #2:	GRAY / YELLOW (# AWG)	IGNITION SWITCH HARNESS **
Ignition #3:	GRAY / YELLOW-2WIRES	IGNITION SWITCH HARNESS **
Accessory:	BLACK/ GREEN	IGNITION SWITCH HARNESS
Brake Light:	GREEN (+)	AT SWITCH ON BRAKE PEDAL BRACKET
Tach Signal:	TAN / YELLOW	AT COIL (3.0L) *
Parking Lights:	BROWN	(+) AT LIGHT SWITCH
Headlights:	RED / YELLOW (+)	HEADLIGHT SWITCH OR BEAM SELECT SW.
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* 2.3L Tach Wire Is BLACK / YELLOW At EDIS Module. On All Explorers Except 3.0L Tach Test Connector Can Be Found On Passenger Rear Corner Of Engine Compartment Near The Blower Motor. ** See Note #127 - Ford Ignition Switch Connection Diagram.

Ford

Explorer

1992-1994

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	2 YELLOW OR 2 GREEN	IGNITION SWITCH HARNESS
OEM Alarm Disarm:	LT.GREEN/ PURPLE (-)	DRIVERS KICK PANEL
Dome Lights/Superv:	BLACK/ LIGHT BLUE	(+) AT PIN SWITCH
OEM Horn:	DARK BLUE (+) OR	YELLOW/LIGHT GREEN (-) IN COLUMN
Power Lock:	PINK / YELLOW	DRIVER'S KICK PANEL ***
Power Unlock:	PINK/LIGHT GREEN	DRIVER'S KICK PANEL ***
Trunk Release:	N/A
Alarm Input Wire:	BLACK/ LIGHT BLUE	(+) AT PIN SWITCH

Lordmarcus42

Member - Posts: 4

Joined: January 02, 2005

Location: Canada

Posted: January 02, 2005 at 9:48 PM / IP Logged

Thank you for your quick response.

Marcus

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Remote Start for 93 Explorer XLT

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.