12volts | lt. blue/red (10A) | + | ignition harness |
Starter | yellow | + | ignition harness |
Second Starter | PURPLE / brown | - | ignition harness |
Notes: The second starter wire is negative trigger thru a 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1083 for wiring information. |
Ignition | pink/white | + | ignition harness |
Second Ignition | N/A | | |
Third Ignition | N/A | | |
Accessory | not required for remote start | | |
Second Accessory | N/A | | |
Keysense | N/A | | |
Power Lock | PURPLE / dk. green | - | BCM, white plug, pin 21 |
Notes: Lock is negative trigger thru a 5.3K ohm resistor. Unlock is negative trigger thru a 2.0K ohm resistor. MUST use relays.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.Can also use Directed 456L interface modules. |
Power Unlock | same as power lock wire | | |
Lock Motor | tan/white | 5wi | BCM, green plug, pin 10 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Unlock Motor | tan/lt. green | 5wi | BCM, green plug, pin 28 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Parking Lights+ | WHITE/ brn (L), WHITE/ org (R) | + | driver kick, harness to rear |
Parking Lights- | WHITE/ brown | - | switch or BCM, black plug, pin 18 |
Notes: The parking lights are negative trigger thru a 2.1K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch. See DirectFax document 1082 for wiring information.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Hazards | WHITE/ dk. blue | - | switch or BCM, black plug, pin 1 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Turn Signal(L) | wht/lt blu (F), wht/dk grn (R) | + | BCM, green plug, pins 1, 2 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Turn Signal(R) | WHITE/ tan (F), WHITE/ brown (R) | + | BCM, green plug, pins 3, 4 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Reverse Light | WHITE/ lt. green | + | BCM, green plug, pin 9 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Door Trigger | see notes | - | BCM, white plug |
Notes: The driver door trigger is purple in pin 6, the passenger door is PURPLE / white in pin 7, the left sliding door is PURPLE / gray in pin 8, and the right sliding door is purple / YELLOW in pin 5. Use all four wires and diode isolate each. Also have to diode isolate from the BCM. Refer to DirectFax document 1076 for wiring information.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Dome Supervision | yellow/brown or yellow/white | + | BCM, white plug, pin 33 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Trunk/Hatch Pin | PURPLE / orange | - | BCM, white plug, pin 29 |
Notes: A diode must be placed inline on this wire to avoid problems with the dome lights and parking lights.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Hood Pin | PURPLE / lt. blue (export model) | - | BCM, white plug, pin 30 |
Notes: The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Trunk/Hatch Release | PURPLE / tan | - | BCM, green plug, pin 6 |
Notes: Hatch release is negative trigger thru a 1.69K ohm resistor. MUST use a relay.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Power Sliding Door | PURPLE / dk. blue | - | BCM, white plug, pin 1 |
Notes: Left power sliding door is negative trigger thru a 1.5K ohm resistor. Right power sliding door is negative trigger thru a 2.7K ohm resistor. MUST use relays.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Factory Alarm Arm | arms on lock with door open | | |
Factory Alarm Disarm | factory remote only | | |
Disarm No Unlock | with ignition and Sentry Key | | |
Tachometer | NOT BROWN / white | ac | ign coil pack or any fuel injector |
Wait to start | N/A | | |
Brake Wire | WHITE/ tan | + | brake pedal switch |
Parking Brake | dk. GREEN / WHITE | - | parking brake switch |
Horn Trigger | dk. GREEN/ purple | - | steering column |
Memory Seat 1 | PURPLE / brown | - | BCM, green plug, pin 24 |
Notes: Memory seat 1 is negative trigger thru a 6.8K ohm resistor. Memory seat 2 is negative trigger thru a 2.1K ohm resistor. MUST use relays.The BCM (Body Control Module) is in the driver kick panel near the parking brake. It has 5 plugs in it, one 6 pin plug and four 34 pin plugs. |
Memory Seat 2 | same as memory seat 1 wire | - | |
Memory Seat 3 | N/A | - | |