2004 Honda CRV, Remote Start

Home / the12volt's Install Bay / Car Security and Convenience / 2004 Honda CRV, Remote Start (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

kyle2000

Member - Posts: 8

Joined: January 17, 2006

Location: United States

Posted: January 28, 2006 at 9:27 PM / IP Logged

I am installing a crimestopper remote start in a 2004 Honda CRV and I need to know if I need to use relays for the wiring of the door lock/unlock circuts. If so, what type relay.

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: January 28, 2006 at 9:35 PM / IP Logged

You shouldn't need Relays, but they would supply a stronger Ground

NEGATIVE Pulse:

Power Lock	WHITE/ BLUE	UNDER DASH FUSE/RELAY BOX
Power Unlock	WHITE/ GREEN	OR LEFT KICK PANEL

Don't Learn from Others Mistakes

You Might Be the One That Knows.

kyle2000

Member - Posts: 8

Joined: January 17, 2006

Location: United States

Posted: January 29, 2006 at 7:15 PM / IP Logged

thanks for the information.

philsan12

Member - Posts: 20

Joined: December 08, 2005

Location: United States

Posted: January 29, 2006 at 8:34 PM / IP Logged

Just put in a 562T Valet. No problems with the start but the door locks won't work.2002 CRV. Gone over the w/b and w/g tons of times. At first it seemed like the clicked but didn't move. Hearing a signal from the brain but no go.

Was starting to wonder about relays even though I have seen no mention about on the CRV.

phil

ringojam

Copper - Posts: 215

Joined: June 10, 2003

Location: Manitoba, Jamaica

Posted: January 29, 2006 at 8:50 PM / IP Logged

Most crv i install in need relays these ar right hand drive jdm modles they all use two relays.,or a door lock module to make the doors operate properly.

Jamaica home of the worlds fastest man.

philsan12

Member - Posts: 20

Joined: December 08, 2005

Location: United States

Posted: January 29, 2006 at 8:54 PM / IP Logged

Man, I thought I was going crazy with reviewing wire.

ThankSSSSSSSSSSSSSSSSSSSSSSSSS!!

Try it Tomorrow. Relay for each wire ? ( - unlock,- lock ) and where to place? Between Valet module and wire above

grey connector. ?

Also have 2 spare DEI 8616 mini relays. Can I use or need the 8617's.

phil

philsan12

Member - Posts: 20

Joined: December 08, 2005

Location: United States

Posted: January 29, 2006 at 9:26 PM / IP Logged

Sorry - confused. Spent 4 hours trying to figure how I snagged the wrong wires which I didn't.

The valet module has a wire that goes to the -unlock and the -lock. Do I place a relay inbetween or somewhere else?

Can I use the DEI 8616 Pre-wired 20/10A relay or do I need a 40A?

Thanks again.

phil

philsan12

Member - Posts: 20

Joined: December 08, 2005

Location: United States

Posted: January 29, 2006 at 9:39 PM / IP Logged

Thanks . 2 wires just put the relays there.

Can I use the low amp one?

phil

ringojam

Copper - Posts: 215

Joined: June 10, 2003

Location: Manitoba, Jamaica

Posted: January 30, 2006 at 8:06 PM / IP Logged

The honda door lock wire you have to test the wires going to the drivers door acuator.Colors are usually yellow/blk,YELLOW /GREEN. cut the wires and install 2 relays reverse polarity,then that should work,check the door lock section to wire properly ok 2004 Honda CRV, Remote Start -- posted image.

2004 Honda CRV, Remote Start -- posted image.

Jamaica home of the worlds fastest man.

philsan12

Member - Posts: 20

Joined: December 08, 2005

Location: United States

Posted: January 31, 2006 at 9:54 AM / IP Logged

So your saying, place the relays between each trigger actuator wire in stead of the -unlock & -lock wire?

Then connect those to the blue and green going to the Valet brain?

phil

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.