98 infinit 130 wiring

i need the color codes and location to install myselfk.f. caine

12volts wht/red or wht/pur    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Starter blk/yel or blk/wht    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Second Starter grn/blk or RED / blu    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Ignition blk/wht or blk/red    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Second Ignition           Third Ignition           Accessory RED / yel or red    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Second Accessory blue or wht/blu    +   ignition harness Notes: The ignition harness wires change color at a plug. The above listed colors show both sides of the plug. Keysense           Power Lock lt. GREEN/ red    -   in drivers door at switch Power Unlock GREEN/ YELLOW    -   in drivers door at switch Notes: Requires a double pulse. Lock Motor BROWN / white      in drivers door at switch Unlock Motor brown      in drivers door at switch Parking Lights+ RED / green      steering column Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger RED / white    -   low in drivers kick Dome Supervision           Trunk/Hatch Pin purple / YELLOW    -   drivers kick or BCM Notes: The BCM (body control module) is located just below the radio. Hood Pin yellow/black    -   BCM Notes: The BCM (body control module) is located just below the radio. Trunk/Hatch Release purple / YELLOW    -   low drivers kick Notes: Must use a relay to interface with this circuit. Power Sliding Door           Factory Alarm Arm arms w/ lock        Factory Alarm Disarm disarms w/ unlock        Disarm No Unlock           Notes: A single negative pulse to the unlock wire will disarm without unlocking. Tachometer WHITE/ green    ac ECM Notes: The ECM is located in the front of the center console on the transmission hump. The wiring is easily reached by removing the small black panel just to the front of the center console on the passenger side. the wire is in the middle row, 7th one in from the left. Wait to start           Brake Wire RED / green    +   at brake switch There are 10 types of people in the world, ones that understand binary and ones that dont.