1992 Mazda MPV, Giordon Top686C
Topic Closed)
Members
Search
Register
Login
Hi everyone, looking for a helping hand with one of these icky alarms. Please bear with me as I'm fairly new to alarm installs and have only done some basic ones before. I bought a Giordon Top686C alarm on ebay like many others and have seen from past posts that even experienced installers hate these things. Of course the manual is all translated to english but as we all know the translation never quite comes across the same. I've attached a wiring diagram below for reference and I just wanted to go over a few things before I start wiring. My wife has a 1992 Mazda MPV Minivan thats been broken in to one too many times for my liking so I figured I'd try and get a cheap alarm in for her. I found the wiring info in the database and I think I've got most of it figured out. I'm not bothering with the engine disengaging system, so I assume I can just tape off the yellow and RED / black and ignore them. I've bolded the things I'm confused about but if someone could verify I have the rest of it right as well that would also be great. Thanks for the help.
James
Constant 12V+ Black Ignition Switch Harness --> Not needed
Starter BLACK / YELLOW Ignition Switch Harness --> Blue wire from starter module splices in hereIgnition BLACK/ White Ignition Switch Harness --> Brown wire from starter module and white wire from main alarm harnass splices in hereAccessory Blue/Red Ignition Switch Harness --> Green wire from start module splices here (Not sure what the whole Air Conditioning thing is about)Not really sure about how to probe for the tach wire, what should I be looking for? I found a white wire that I think is in this correct location but it appears to fluctuate voltage like an A/C voltage almost.
Tach White Or WHITE/ Black (-) at Test Connector Driver's Fender --> Purple wire from main alarm harnass
Brake Switch WHITE/ Green Brake Switch --> Orange wire from main alarm harnass
Trunk Pin n/a Works with Dome Light --> Not neededParking Lights RED / Black Or RED / White at Fuse Panel --> Both brown wires from main alarm harnass splices? Head Lamp RED / Black Light Switch --> Not neededDoor Trigger Pink (-) Driver's Pin Switch or Fuse Panel --> Blue wire from main alarm harnass splicesNow I'm a little confused about the autodoor locks as this van has no driver side switch to open the doors however a key unlocking either driver or passenger door unlocks all doors.
Door Lock GREEN/ Black (-) Driver's Kick Panel or Timer below AC HSG --> White wire from door lock harnass splices?Door Unlock GREEN / WHITE (-) --> WHITE/ Black wire from door lock harnass splices?
Other connections:
Black from main alarm harnass --> - Battery
Red from main alarm harnass --> + Battery
Yellow + Yellow/Black from door opening harnass --> Ground
Pink from main alarm harnass --> Horn +
Horn - --> Ground
Tape off from main alarm harnass (not connected)
Green (Trunk)
Yellow (Extinguishing control)
Blue/White (gate + trigger switch)
Taped off from door opening harnass
Orange + ORANGE / Black
------ Alarm wiring picture below -----
Sorry, you can NOT post a reply.
This topic is closed.
Printable version
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
| Search the12volt.com |
Friday, May 9, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
