2005 mitsubishi montero

Home / the12volt's Install Bay / Car Security and Convenience / 2005 mitsubishi montero (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

ramiroggenbu

Member - Posts: 9

Joined: October 28, 2005

Location: United States

Posted: December 16, 2006 at 2:11 AM / IP Logged

does anyone have the wiring diagram for a 2005 mitsubishi montero? it is not a sport if that makes a difference.

Thanks for the help

Mike R

rudydapimp

Copper - Posts: 390

Joined: February 27, 2006

Location: United States

Posted: December 16, 2006 at 10:57 AM / IP Logged

12volts	blue/white (40A)	+	ignition harness
Starter	BLACK / YELLOW	+	ignition harness
Second Starter	N/A
Ignition	blue/black	+	ignition harness
Second Ignition	N/A
Third Ignition	N/A
Accessory	blue/red	+	ignition harness
Second Accessory	blue / YELLOW	+	ignition harness
Keysense	RED / blue		ign harn or ETACS ECU, pin 26
Notes: This wire rests at ground with the key out of the ignition cylinder, and goes to an open circuit when the key is inserted. The ETACS ECU is attached to the back of the fuse box.
Power Lock	lt. GREEN/ wht to lt. GREEN/ red	-	ETACS ECU, pin 53
Notes: The ETACS ECU is attached to the back of the fuse box.
Power Unlock	BROWN / white	-	ETACS ECU, pin 54
Notes: The ETACS ECU is attached to the back of the fuse box.
Lock Motor	blue/black	5wi	15 pin plug below fuses, pin 8
Unlock Motor	blue/red	5wi	13 pin plug above fuses, pin 13
Parking Lights+	GREEN/ orange or GREEN / WHITE	+	driver kick, harness to rear
Parking Lights-	N/A
Hazards	green	-	switch or ETACS ECU, pin 27
Notes: The ETACS ECU is attached to the back of the fuse box.
Turn Signal(L)	GREEN/ YELLOW	+	15 pin plug below fuses, pin 7
Turn Signal(R)	GREEN/ red	+	15 pin plug below fuses, pin 14
Reverse Light	RED / green	+	driver kick, harness to rear
Door Trigger	RED / green	-	15 pin plug below fuses, pin 10
Dome Supervision	use door trigger wire
Trunk/Hatch Pin	common with door trigger wire
Hood Pin	blue/black	-	ETACS ECU, pin 48
Notes: The ETACS ECU is attached to the back of the fuse box.
Trunk/Hatch Release	N/A
Power Sliding Door	N/A
Factory Alarm Arm	lt. GREEN/ blue to blue	-	ETACS ECU, pin 50
Notes: Meter this wire while turning the key in the driver door key cylinder. The ETACS ECU is attached to the back of the fuse box.
Factory Alarm Disarm	brown	-	ETACS ECU, pin 52
Notes: Meter this wire while turning the key in the driver door key cylinder. The ETACS ECU is attached to the back of the fuse box.
Disarm No Unlock	see factory alarm disarm
Tachometer	WHITE/ green	ac	engine speed detection connector
Notes: The engine speed detection connector is a 3 pin plug in the fuse/relay box under the hood. Can also go to one of the ignition coils and use the wire that is NOT blue/black or black.
Wait to start	N/A
Brake Wire	blue/orange	+	brake pedal switch
Parking Brake	yellow/black	-	parking brake switch or cluster
Horn Trigger	lt. GREEN/ black	-	switch or ETACS ECU, pin 42
Notes: The ETACS ECU is attached to the back of the fuse box.
Memory Seat 1	N/A
Memory Seat 2	N/A
Memory Seat 3	N/A

Interface Module:	Category: Immobilizer Bypass	Required: Yes	Type: Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Standard on all models.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2005 mitsubishi montero

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.