92 nissan sentra door lock

HAVE INSTALLED A BLACKWIDOW 3150 ALARM ON 92 NISSAN SENTRA.THIS VEHICLE HAS A SINGLE WIRE DOOR LOCK(LIGHT GREEN/ BLACK AT DRIVER DOOR)INSTALLED A SINGLE RELAY AND WIRED UP AS ILLUSTRATED BY OMEGA WIRING SCHEMATICS BUT STILL DOESNT WORK PROPERLY.DOORS LOCK BUT DOES NOT UNLOCK WITH ALARM.

ANY IDEAS?THANKS

Is your unlock wire connected directly to the lt.GREEN/ black wire?  It sounds like you must have the unlock setup like this: pin 85 to your unlock output from the alarm, pin 86 to 12v+, pin 30 and 87a to either side of the cut lt.GREEN/ black wire, and pin 87 to nothing.  If you have your setup just like this, you may need to use a relay for the unlock pulse: so then put pin 85 to unlock output, pin 86 to 12v+,  pin 30 to the lt.GREEN/ black wire, pin 87a to nothing and pin 87 to ground.

THIS IS HOW I HAVE THE SET UP.SWITCH SIDE OF SINGLE WIRE TO PIN 87A,MOTOR SIDE AND NEGATIVE UNLOCK OUTPUT FROM ALARM TO PIN 30,NEGATIVE LOCK OUTPUT FROM ALARM TO PIN 85. 12 VOLT TO PIN 86.PIN 87 NOT USED.(LT GREEN/ BLACK WIRE IS CUT)