2001 Dodge Ram 2500 Diesel Alarm Wiring

Please Help if anyone can. I removed the alarm from my old chevy at trade in time and now have a 2001 Dodge ram 2500 Cummins Turbo Diesel. I Really need the install manual for my alarm its a Autopage RS-662 And need to know what wires are what up under the dash. CAN ANYONE HELP?? THANK YOU Very much in advance.

DIRECTWIRE™ WIRING INFORMATION - DODGE / RAM PICKUP / 2001 / Keyless Entry [PRINT THIS PAGE] 12volts      red and pink/black       +       ignition harness Starter      yellow       +       ignition harness Ignition      dk. blue       +       ignition harness Power Lock      ORANGE / purple       5wi      driver door harness Notes: Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green. Power Unlock      pink/purple       5wi      driver door harness Notes: Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green. Lock Motor      ORANGE / black             driver door harness Unlock Motor      pink/black             driver door harness Parking Lights+      BLACK / YELLOW             headlight switch Parking Lights-                  Hazards                  Turn Signal(L)                  Turn Signal(R)                  Door Trigger      yellow       -       headlight switch or DKP Notes: To avoid dome delay, use tan for the drivers door and BLACK/ lt. blue for the passenger door. Both wires are located at the central timer module to the right side of the steering column. Use both wires and diode isolate each. Dome Supervision      use door trigger             Trunk/Hatch Release                  Power Sliding Door                  Factory Alarm Arm      lt. GREEN/ orange       -       driver door harness Notes: Arm is negative trigger thru a 644 ohm resistor. Disarm is negative trigger through a 1.5K (1500) ohm resistor. MUST use relays. Factory Alarm Disarm      same wire             Disarm No Unlock                  Horn Trigger      BLACK/ red       -       steering column Memory Seat 1                  Memory Seat 2                  Memory Seat 3                  Interface Module:      Category: Immobilizer Bypass      Required: No      Type: N/A Part #: N/A Notes: Smart Starter Kill Relays: Not Available warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. commit your way to jehovah and he will act in your behalf. psalms 37:5