the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

bmw x5 2002 turn signals


Post ReplyPost New Topic
< Prev Topic Next Topic >
trackerdario 
Member - Posts: 2
Member spacespace
Joined: May 16, 2012
Location: Croatia
Posted: May 16, 2012 at 3:38 PM / IP Logged  
Hi to everyone,I've been observing this forum for a long time,been very helpful every time,
The point is i'm stuck on some point of wiring a car alarm system on a BMW X5 3.0 automatic 2002 y.
I've found the wiring diagram here,but there is no information on connecting the turn signals to the alarm,only parking lights.
I would be very thankful if someone could help me about this problem
I've searched for the wires,and so far I found out that the some turn signals come out from some unit in the lower right side under the glove box,but can't find some "common"L and R wires to hook it up with the alarm
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: May 17, 2012 at 12:50 AM / IP Logged  
Junction module, left hand side, top of passenger kick panel*, blue/green X 2, blue / YELLOW X2 and blue/brown X 21.
Diode 1N5404 separation.
*That location applies to UK right hand drive but they should all be there.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: May 17, 2012 at 1:00 AM / IP Logged  
Further referencing, yes it's the light module and it may well be the right hand side on l/h/drive models, a further choice might be to take the BROWN / blue, pin 7 on the black 54 pin plug at the light module.
Ground it the indicators should work for the time you have it grounded, if not and it latches, that is you have to ground it a second time to turn off then the other post applied. They changed from constant ground trigger to latching around then so it's worth checking, save you wiring to 6 with 6 diodes.
trackerdario 
Member - Posts: 2
Member spacespace
Joined: May 16, 2012
Location: Croatia
Posted: May 17, 2012 at 3:51 PM / IP Logged  
Thanks for a fast reply
I forgot to write down that I found that wire wich when grounded turns on the "hazzard" lights,and grounded again turns them off,the wire is going from the hazzard lights switch near the gear lever.
But the alarm gives two pulses (+)when activating,and three when deactivating,and then the lights would stay on flashing,so can't hook them up there
But I'll try the three wires you mentioned above,I assume that each turns one side,or? And the third than?
I'm going back to the garage tomorow to check them wires and see where I'm at
Thanks again
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: May 17, 2012 at 4:17 PM / IP Logged  
OK, thank you you've answered my question about the BROWN / blue, it's latching so we can't use it.
Not 4 wires, read my post again, 6 SIX, two of each, 2 x front, 2 x side and 2 x rear.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Monday, May 12, 2025 • Copyright © 1999-2025 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer