05 Nissan Titan Alarm/Stereo Wiring

Need alarm and stereo wiring

DIRECTWIRE™ WIRING INFORMATION - NISSAN / TITAN / 2005 / Security 12volts green (40A)   +   ignition harness Starter brown   +   ignition harness Ignition BLACK/ red   +   ignition harness Power Lock blue   -   driver door module in door Power Unlock red (double pulse)   -   driver door module in door Lock Motor purple   5wi BCM to right of column, pin 65 Unlock Motor green   5wi BCM to right of column, pin 59 Disarm Defeat GREEN/ YELLOW   5wi BCM to right of column, pin 66 Parking Lights+ RED / blue   +   dimmer switch on dash Parking Lights- N/A        Hazards WHITE/ black   -   BCM to right of column, pin 29 Turn Signal(L) GREEN/ black   +   BCM to right of column, pin 60 Turn Signal(R) GREEN/ YELLOW   +   BCM to right of column, pin 61 Door Trigger see notes   -   BCM to right of column Notes: The LF door trigger is lt. blue in pin 47. The RF door trigger is RED / blue in pin 12. The LR door trigger is RED / yellow in pin 48. The RR door trigger is RED / white or gray in pin 13. Use all four wires and diode isolate each. Dome Supervision blue   -   BCM to right of column, pin 63 Notes: The blue wire is for the dome lights and puddle lights. For the step lights use RED / white in pin 62 at the BCM. Trunk/Hatch Pin N/A        Hood Pin N/A        Trunk/Hatch Release N/A        Power Sliding Door N/A        Factory Alarm Arm arms with lock        Factory Alarm Disarm disarms with unlock        Disarm No Unlock single pulse power unlock wire        Tachometer NOT WHITE/ blue or black   ac   any ignition coil Horn Trigger RED / white   -   horn switch Memory Seat 1 lt. GREEN/ black   -   memory mod. left of column, pin 9 Memory Seat 2 pink/blue   -   memory mod. left of column, pin 25 Memory Seat 3 N/A   -      Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556UW Alternate Part1 #: 555U Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes: Standard on the SE and LE models. Optional on the Crew Cab XE models.        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

thanks for alarm, now anyone with stereo?

DIRECTWIRE™ WIRING INFORMATION - NISSAN / TITAN / 2005 / Audio Radio 12v yellow   +   radio harness Radio Ground (chassis)        Radio Ignition purple   +   radio harness Radio Illumination RED / blue   +   radio harness Factory Amp Turn-on GREEN / WHITE   +   radio harness or amplifier Notes: If equipped, the BOSE amplifier is to the right of the steering column, behind the BCM. Power Antenna N/A        LF Speaker +/- blue/white - blue/red   +,- radio harness or amplifier Notes: If equipped, the BOSE amplifier is to the right of the steering column, behind the BCM. RF Speaker +/- WHITE/ black - blue/black   +,- radio harness or amplifier LR Speaker +/- lt. blue - BLACK / YELLOW   +,- radio harness or amplifier RR Speaker +/- ORANGE / blue - RED / blue   +,- radio harness or amplifier Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 556UW Alternate Part1 #: 555U Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes: Standard on the SE and LE models. Optional on the Crew Cab XE models.        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.