the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1997 Eclipse automate antitheft/ keyless entry


Post ReplyPost New Topic
< Prev Topic Next Topic >
mitsushocker 
Member - Posts: 17
Member spacespace
Joined: January 18, 2005
Location: United States
Posted: January 18, 2005 at 6:31 PM / IP Logged  
Mistushocker would like help with automate antitheft/ keyless entry that seems to be inhibiting start of a newly bought 1997 Mitsubishi Eclipse GS M/T. I have taken apart a few engines in my time, 2 of this same make/model, am a pilot of 7 years, college grad with honors etc... etc.... etc.... so I have a little know how of wiring, schematics, and how stuff works. Some things just dont seem to make sense and I hope someone might help. I have just taken apart the engine of my 97 Eclipse GS to install head gasket, water pump, and timing belt beacaue there was a slight oil/pressure leak from #4 cylinder. May as well get timing belt and water pump while all is apart of course... :) After putting all the parts back together, I put the key into the ignition, turn 2 clicks, and tighten down the neg side of batt. to override Automate 467 setting off alarm etc, try to start, nothing. Push the door open and close button on the remote and try again, still nothing. All except a check engine light that flashes until I shut the alarm off and a clicking near my left foot. Tried to reset alarm and ECS many times, still stumped, checked fuses, and even tried to pull the onboard anti-theft fuse. (manufacturer as well as aftermarket anti-theft) Have tried many combinations of disconnecting battery and pushing remote buttons even for extended time periods. My solution is that a elec switch is stuck somewhere in the alarm and to cut out the automate. Any other suggestions would be appreciated......
1997 Mitsubishi Eclipse GS
leave a msg after the beep beep.....
mitsushocker 
Member - Posts: 17
Member spacespace
Joined: January 18, 2005
Location: United States
Posted: January 18, 2005 at 7:01 PM / IP Logged  
ok well I have one adjustment to my claim.... the remote is automate 467, unsure exact model automate ... will investigate and post update....1997 Eclipse automate antitheft/ keyless entry  -- posted image.
1997 Mitsubishi Eclipse GS
leave a msg after the beep beep.....
mitsushocker 
Member - Posts: 17
Member spacespace
Joined: January 18, 2005
Location: United States
Posted: January 19, 2005 at 4:41 PM / IP Logged  
working with an automate model #2, remote 467, possibly looking for a wiring diagram for disconnect/ reconnect ignition/ starter wiring ....
1997 Mitsubishi Eclipse GS
leave a msg after the beep beep.....
mitsushocker 
Member - Posts: 17
Member spacespace
Joined: January 18, 2005
Location: United States
Posted: January 19, 2005 at 8:04 PM / IP Logged  
disconnected automate, reset ecu, car started.... the end 1997 Eclipse automate antitheft/ keyless entry  -- posted image.
1997 Mitsubishi Eclipse GS
leave a msg after the beep beep.....

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Monday, May 6, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer