Thinning Resin?

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / Thinning Resin? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

bluetruck

Copper - Posts: 115

Joined: December 26, 2004

Location: United States

Posted: April 02, 2005 at 9:40 AM / IP Logged

can you just mix a little acetone with the resin to thin it? i was watching overhaulin' and the resin they were using on the dash was much thinner than the stuff i use, is that how they thin it down? i seem to remember a post abotu this but i could not find it. anyone know what im talking about? obviously i dont.

oonikfraleyoo

Gold - Posts: 1,069

This member has made a donation to the12volt.com. Click here for more info.

Joined: January 04, 2005

Location: United States

Posted: April 02, 2005 at 10:47 AM / IP Logged

Yeah that would do fine.

Nik

Jeeputer Progress

[|||||||||||-] 90%

Check it out.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Thinning Resin?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.