resin, hardener

Ok, here's my dumb butt did. I wanted to fiberglass the inside of a sub enclosure, but due to being low on hardener, the mixture did not have the right ratios, but I did it anyways. Of course, the resin did not set up properly. Question is, I'm fixing to go get a new kit, would it be ok just to mix it a little higher and brush it on what is already there, or should I try to clean off the other and start over. Thanks a bunch. Oh yeah, this was my first expierence with fg, so go easy on me.

Yeah, I scraped off all the original wet stuff I could, mixed up some new, applied it, and all is good now. Should make for one tough enclosure.