sub wiring

This is all going in my boat keep in mind!! Hey here is what I've got.. Two dvc 2ohm cvx subs two svc 4ohm Sony subs and a 1500 rms @ 1 ohm mtx mono. The cvx subs are going in a .9 qubic feet sealed inclosure each on the deck of the boat and Sony subs in a bandpass in the hull of the boat.. So here is my questions for this setup!! I want to run the cvx subs in paralell with the coils in series to get a 2ohm load. The sony subs in paralell to get a 2ohm load. All on the one mtx amp. Will this give the amp a 1ohm load? And will tha Sony subs get half the power because they ate 4ohm? If so that's what I want.. Can it even be wired like that? Any sugestions or ideas feel free!!! Thanks chris

Yes the amp will see a 1 ohm load.  Each speaker will recieve the same amount of power.  As far as the amp and Ohms Law are concerned, each is a 4 ohm driver.

Thanks this setup should work nice then.. Is there any way to send more power to the kicker cvx subs than the sony subs in this setup?

Sweet I was thinking that but what will the load be on the amp then? My biggest worry was that it wasn't gonna work together I see it will thanks chris

The amp will then see a 1.6 ohm load