the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

OZ Matrix vs Dynaudio


Post ReplyPost New Topic
< Prev Topic Next Topic >
YStress 
Member - Posts: 8
Member spacespace
Joined: January 20, 2004
Location: United States
Posted: February 25, 2004 at 4:43 PM / IP Logged  
As I continue my search for componets, I am considering the OZ Matrix components for my convertible.  I remember listening to them the first year they came out and I liked the sound.  I was wondering if anyone had any thoughts as to how the CS130s stack up against the Dynaudio 220MKIIs?
forbidden 
Platinum - Posts: 5,352
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Mobile Audio and Video. Click here for more info.spacespace
Joined: November 01, 2003
Location: Alberta, Canada
Posted: February 25, 2004 at 4:50 PM / IP Logged  
Convertable = loss of top end and poor off axis response for most speakers. Try to find tweeters that have a titanium dome rather than silk or poly etc. The ones that I and many others use when faces with a convertable are MB Quart. They have stellar top end thanks to the high efficiency and capabilities of the titanium dome tweeter and amazing off - axis reponse. Consider these fine speakers as well.
Top Secret, I can tell you but then my wife will kill me.
YStress 
Member - Posts: 8
Member spacespace
Joined: January 20, 2004
Location: United States
Posted: February 25, 2004 at 4:56 PM / IP Logged  
My original choice.  However, I am running 100 watts/ channel (ZAPCO  200) and I was thinking of mounting the tweeters in the kick panels with the the midbass.  Think this will overcome the top end loss?
forbidden 
Platinum - Posts: 5,352
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Mobile Audio and Video. Click here for more info.spacespace
Joined: November 01, 2003
Location: Alberta, Canada
Posted: February 25, 2004 at 5:05 PM / IP Logged  
Not really, the sound out of a tweeter is highly directional. Ideally this is the best spot as it makes a much closer pathlength for the top end, but the minute you have a passenger in the vehicle the tweeters are usually now covered. It is the best idea for a competitor but if this is not you and you want to enjoy your music then try this. My suggestion is to tape the tweeters into place in a couple of different positions and have a listen to them with the top up and down at different speeds, you will be amazed by the difference that mounting locations will make in your vehicle.
Top Secret, I can tell you but then my wife will kill me.
YStress 
Member - Posts: 8
Member spacespace
Joined: January 20, 2004
Location: United States
Posted: February 25, 2004 at 6:13 PM / IP Logged  

Thanks.  I was planning on this.  I have a door panel with a  few good tweet mounting options.  I was going to try a few different places to see what works best.  I was also going to get rear speakers to add fill when the top is down.  75% of the time I do not have a passenger, so I wanted to try to balance SQ with usability. 

Back when I installed professionally, I had some experiences with MB Quart. ;good off-axis response from the tweets but muddy mid & mid-bass.  I have had Dyn's in a '92 Jeep Wrangler with the same amp. With the top off, I had no trouble with high frequencies as the tweeter was mounted in the factory dash location (forward facing), but I also had no stage when the top was up.  As for mids, I had the Dyn dome mids also in the factory location and a pair of 7" drivers/channel in the floor facing up.

What I am trying to figure out is should I go the MB Quart route (QSD 213 rated 85db and expensive), Dynaudio (220MKII rated 90bd and less expensive) or some other option like Focal (also expensive) or OZ (cheapest of the bunch).  On paper the OZ ranks well compared to the Dyn's and Isave about $100.  Just looking for people's feedback.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer