Kenwood DDX7015 problem

Home / the12volt's Install Bay / Car Audio / Kenwood DDX7015 problem (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

fnivme2

Member - Posts: 2

Joined: August 02, 2004

Location: United States

Posted: August 02, 2004 at 12:18 PM / IP Logged

While doing some work on my 2004 F250 Superduty PSD I had to disconnect the batteries. After reconnecting the batteries I found that the receiver would not turn on. None of the wiring for the stereo was touched, the fuses ohm out good and there is 12V coming out of both connectors in the rear of the unit.

Any ideas on what would have caused it to die?

louie

Member - Posts: 6

Joined: April 05, 2004

Location: United States

Posted: August 06, 2004 at 12:14 AM / IP Logged

some deck have a reset but you should try that or check to see if you have good ground.

Mac21

fnivme2

Member - Posts: 2

Joined: August 02, 2004

Location: United States

Posted: August 06, 2004 at 10:43 AM / IP Logged

Thanks. I forgot to mention that I had tried the reset.

Figure I will leave it at the service center for the week I will be out of town.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Kenwood DDX7015 problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.