monoBlock , 2 Subs , Impedance

I'm Running 2 10inch Bazooka EL's off of a Bazooka EL MonoBlock (600w max)

Am i running my amp in 2ohm or 1ohm??

The subs are 4 Ohm's each

The Subs are wired in Paralell

The Amp Runs Hot and sometimes CLicks out..

4Ga all the way.. Fused at both ends.. 

Im used to bridging stereo amps. this mono-block has me a little confused..

Hunter S. Thompson for sheriff

you are pushing a 2 ohm load to your amp if the speakers are SVC, if they are DVC you would be pushing 1

i bet in blowing a good 200watts off on the heatsink! Hunter S. Thompson for sheriff

An amp is designed to get hot, too hot though and it is going to go into protection. This is usually caused by an incorrect gain setting (too high), a bass boost (too high), or poor circulation. If it is scorching hot outside, the inside of a vehicle gets darn hot as well. Ensure the amp has proper ventilation and turn the gains down. It is indeed running at 2 ohms if the subs are 4 ohms each and wired in parallelTop Secret, I can tell you but then my wife will kill me.

You said "4Ga all the way.. Fused at both ends.. " do you mean that you have fuse on your ground?