ohm configerations with type r's?

Home / the12volt's Install Bay / Car Audio / ohm configerations with type r's? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

rallysport

Copper - Posts: 172

Joined: April 10, 2004

Location: United States

Posted: December 10, 2004 at 2:17 AM / IP Logged

i want to get 2 10inch type r's to replace my dying jls. what kind of ohm loads are possible seeing as how they are avalilabe in DVC 2 or 4 ohm? i suck and can figure out this ohmload thing for the life of me. i planned on getting a MRD-M501 to power then so i assume a 2 ohm load is ideal?

Teamrf

Gold - Posts: 1,031

Joined: January 13, 2004

Location: United States

Posted: December 10, 2004 at 2:37 AM / IP Logged

If you get an amp that is 2-ohm stable get the dual 2's

~The Rookie~

Rookie of the year that is...

Don't let the smoke out of your equiptment..it doesn't go back in.

wheelerdr

Copper - Posts: 337

Joined: October 25, 2004

Location: Louisiana, United States

Posted: December 10, 2004 at 2:39 AM / IP Logged

I would go with 2 2ohm+2ohm wire each sub in series and then run both subs to the amp in parallel this will creat a 2 ohm load. this short cut will show you how to wire your subs http://www.jlaudio.com/tutorials/wiring/index.html#2dvcsp

then just run both + to the + on the amp and run both - to the - on the amp

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

ohm configerations with type r's?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.