wiring coaxials

Yeah, you treat them like a SVC.  There is just one positive and one negative, so the speaker wires are connected to them.  I crimp and solder F-disconnects to the wires and push them onto the speaker terminals.  Buy disconnects that fit the speaker terminals, so you might want to take the coaxials into a audio store and get the right sizes.  The neg may be a smaller size than the pos.

Connect the rears to the head unit factory wiring to the rears, and run 16 gauge speaker wire from the amp up to the front door coaxials.  Just run the wiring with some play, under carpet edges and beneath trim molding, then through the grommet that's already in the door hinge side.  Follow the factory wiring.  Just like any wiring run, any place where the wires will go through a hole in the sheet metal requires the use of a rubber grommet to keep wires from being frayed.  When you disconnect any factory wiring from the head unit, always tape and secure the ends so they don't touch anything. 

Found the grommett already..thanks